Whirlpool AWE 6315/P INSTRUCTION FOR USE

GB AWE 6315/P

PROGRAMME CHART

B

A C D

A. “Start” Button

- lights up when activated -

B.Programme sequence indicator

C.“Spin Speed Selection” Button

D.“On/Off” button

-does not light up when activated

(the dot on the button is not a lamp) -

1)Do not use liquid detergents.

2)For improved garment care, spin speed is restricted to 600 rpm in this programme.

3)For improved garment care, spin speed is zero in this programme.

						Max.		Detergents and additives										Special Options				Max.
																						Spin
						load	Prewash		Main			Softener				Bleach		Half Load	Intensive		Rinse
Programme		Care			Type of wash / Notes																	Speed
									Wash										Rinse		Hold
		Labels
						kg												Połowa	Super		Stop	rpm
																		ładunku	płukanie		płukanie
Cotton 95°	Pranie Wstępne				Heavily soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton	5.0	Yes 1)		Yes													800
with prewash	Bawełniane 95°				and linen.
Synthetic 60°	Pranie Wstępne				Heavily soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide	2.0	Yes 1)		Yes							—						600 2)
with prewash	Syntetyczne 60°				(Perlon, Nylon) or blends with cotton.
Delicate 40°	Pranie Wstępne				Heavily soiled curtains and delicate clothing, dresses, skirts, shirts and blouses.	1.5	Yes 1)		Yes							—		—	—			600 2)
with prewash	Delikatne 40°
Cotton	Bawełniane				Normally to heavily soiled bed linen, table linen and underwear, towels, shirts etc. made	5.0	—		Yes													800
95° - 60° - 40°	95° - 60° - 40°				of cotton and linen.
Daily Mixed 40°	Codzienne 60 min.				Slightly to normally soiled textiles made of cotton and/or synthetics.	3.0	—		Yes							—						800
Synthetic 40°	Syntetyczne 40°				Normally soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira),	2.0	—		Yes							—						600 2)
					polyamide (Perlon, Nylon).
Delicate 40°	Delikatne 40°				Curtains and delicate clothing, dresses, skirts, shirts and blouses.	1.5	—		Yes							—		—	—			600 2)
					Only woollens with a felt-free finish, labelled with the woolmark and identified as	1.0	—		Yes							—		—	—			600 2)
Wool 40°	Wełniane 40°				machine washable.
					If you select “Rinse Hold” do not leave items to soak for too long.
Handwash 30°	Pranie ręczne 30°				Textiles made of silk, linen, wool and viscose marked as “handwashable”.	1.0	—		Yes							—		—	—			— 3)
					If you select “Rinse Hold” do not leave items to soak for too long. No spinning.
Rinse +	Płukanie i delikatne	—			Programme for treating delicate laundry with starch or softener.	2.0	—		—							—						600 2)
Gentle Spin	wirowanie
Rinse + Spin	Płukanie i wirowanie	—			Programme for treating cotton or linen laundry with starch or softener.	5.0	—		—							—						800
Spin	Wirowanie	—			Programme to spin cotton or linen laundry intensively with maximum spin speed.	5.0	—		—				—			—		—	—		—	800
Gentle spin	Delikat. wirowanie	—			Programme to spin delicate laundry gently with a restricted spin speed.	2.0	—		—				—			—		—	—		—	600 2)
Drain	Wypompowanie	—			Drain only - no spinning. Alternative method of terminating programme after “Rinse Hold”.	—	—		—				—			—		—	—		—	—

N.B. This machine is controlled by sensors. Please avoid excessive detergent dosing.

Whirlpool is a registered trademark of Whirlpool USA

5019 312 10423

CONSUMPTION DATA

	Temperature Selector	Load	Water	Energy	Approx. Programme
Programme					Duration
	(°C)	(kg)	(l)	(kWh)	(hours : minutes)
Cotton	95	5.0	63*	1.80	2:05
Cotton	60	5.0	52	0.95	2:05
Cotton	40	5.0	52	0.60	2:05
Daily Mixed	40	3.0	49	0.48	1:00
Synthetic	60	2.0	56	0.80	1:30
Synthetic	40	2.0	56	0.40	1:20
Delicate	40	1.5	60	0.55	0:45
Wool	40	1.0	60	0.50	0:40
Handwash	30	1.0	60	0.30	0:50

Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized conditions in compliance with standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash.

The data on the “Energy Label” refer to the programme “Cotton 60°C”.

*To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out.

PREPARATION OF WASH CYCLE

1.Load the machine, close the drum doors and check that they are properly locked.

2.Add detergents and additives into the dispenser to no more than the “MAX” level mark, as follows:

• Programme with pre and main wash

• Main wash programme without prewash

• Fabric softeners and conditioners

• Chlorine bleach

• Stain remover agents

• Anti-scale agents (if necessary)

3.Press the “On/Off” button.

The lamp of the “Start” button flashes.

4.Turn the programme selector knob to the desired programme. The lamp of the programme’s standard spin speed lights up.

SELECT THE DESIRED OPTION

Selecting or deselecting an option can be done at any time during the programme. The option will be applied as long as the corresponding programme phase has not been executed yet.

“Half Load” button

•Can be used for small loads and lightly soiled laundry.

•Reduces the water consumption especially during the rinses.

“Intensive Rinse” button

•The amount of water is increased to ensure a more intensive rinse.

•This option is particularly suitable for areas with very soft water, washing baby linen and people with skin allergies.

“Rinse Hold” button

•The laundry remains in the last rinse water without progressing to the final spin cycle to avoid creasing and prevent colours from fading.

•This option is particularly recommended for the “Synthetic”, “Delicate” and “Daily Mixed” programmes.

•This function is particularly useful if you want to postpone spinning to a later time, or if you want to drain only.

•As soon as the appliance stops in the rinse hold, the lamp of the “Start” button flashes.

Appliance in “Rinse Hold”:

•Press the “Rinse Hold” button or the flashing “Start” button: the programme will terminate automatically with the selected spin cycle.

•If you do not wish to spin the clothes, turn the programme selector knob to the “Drain” programme and press the “Start” button again.

Spin Speed selection button

•Every programme has an automatically preset spin speed.

•Press the button to set another spin speed.

•If spin speed “0” is selected, the final spin is cancelled, and the programme ends with a drain cycle.

PROGRAMME START

Verify that the appliance is switched on.

Turn on the tap and press the “Start” button. The indicator lamp of the “Start” button stops flashing and lights up.

Note: If there is a power interruption or if the appliance is disconnected during the cycle, the programme will run again from the point where it was interrupted.

END OF WASH CYCLE

•The “End” lamp of the programme sequence indicator lights up.

1.Press the “On/Off” button to switch off the machine.

2.Turn the tap off.

3.Wait for the lid to unlock (about 1 minute).

4.Open the lid and the drum doors and unload the machine. Leave the lid open for some time to allow the inside of the appliance to dry.

CHANGE THE PROGRAMME DURING THE WASH CYCLE

1.Switch the appliance off by pressing “On/Off”.

2.Turn the programme selector knob to the new programme.

3.Switch the appliance on again by pressing “On/Off”. The “Start” button flashes. If necessary, select additional options and different spin speed.

4.Start programme by pressing the “Start” button.

PAUSE/INTERRUPT A PROGRAMME

If, for any reason, you wish to interrupt the programme for a certain time and continue it later:

1.Press the “On/Off” button.

2.After the desired pause, press again on the

“On/Off” button.

CANCEL PROGRAMME

1.Switch off the appliance by pressing “On/Off”.

2.Turn the programme selector to “Drain”.

3.Switch the appliance on again by pressing “On/Off”. The lamp of the “Start” button flashes.

4.Press the “Start” button to start the “Drain” programme.

Whirlpool is a registered trademark of Whirlpool USA

5019 312 10423