Whirlpool AKZ 209/AL/01, ADP 951/3 WH, AKZ 209/NB/01, AKZ 209/IX/01 INSTALLATION

ADP 951

PROGRAMME CHART

Salt level indicator

Add regeneration salt.

Rinse aid level indicator

Add rinse aid.

Programme

Symbol and

temperature

Pre-rinse

Rapid 40° C

Eco 50° C

Universal 65° C

Programme progress indicator Pre-rinse

Only lights up for programmes with prewash (the symbol “+” in the table below indicates that detergent must be added).

Rinse /Washing Drying

End

Programme end

Load

Crockery and cutlery

Crockery to be washed later. Lightly soiled crockery with no dried-on food. Normally soiled crockery with dried-on food. Normally soiled crockery.

Start button indicator lamp

Switches on when the dishwasher is operating. Flashes when a fault occurs. Switches off at the end of the programme.

Detergent

Pre-rinse

(small

compartment)

--5.00.029---

- + 13.0 0.85 30 - - -

+ + 16.0 1.40 86 - - -

- + 14.0 1.50 73 - - -

Washing

(large

compartment)

Consumption *

Normal load

Water (Liter)

Energy

(kWh)

Time

(Min.)

Normal 65° C

*) Values for normal conditions. Values may vary in relation to usage, e.g. different loads, water temperatures, water hardness and power supply voltage.

1) Programme recommended when usind detergents of type A (non enzyme-based detergents).

2) Programme recommended when using detergents of type B (enzyme-based detergents). Reference programme for Test Institute and energy label.

Normally or heavily soiled crockery.

+ + 20.0 1.63 98 - - -

(We reserve the right to make technical modifications)

5019 100 91175

Quick Reference Guide

Daily check list

1. Arrange crockery so that items do not touch each other.

2. Load cups at an inclination to facilitate water circulation.

3. In general, place cutlery in the basket with the handles positioned downwards, but ensure that any sharp knives and forks that might cause injury are placed in the basket with the handles positioned upwards.

4. Make sure the water jet can reach all loaded items and that the spray arms rotate freely.

5. Turn on the water supply tap before starting the dishwasher.

Important

• Switch off the dishwasher once the “Start” indicator lamp has

switched off. If you switch off the dishwasher during a wash cycle, when switched on again the dishwasher resumes the cycle from where it was interrupted.

• If a fault occurs or you wish to change the current programme, press the “START” button for about 5 seconds until the Start indicator lamp switches off ! Refer to the “Troubleshooting Guide” in these user instructions to remedy any problems.

• If a regeneration salt is to be added, IMMEDIATELY washing programme, in order to eliminate any residual salt.

• Sometimes even when the regeneration salt container is full, the corresponding indicator lamp may illuminate during the first wash cycle.

start a

Crockery holders:

• Down: cups and long-stemmed glasses.

• Raised: plates.

Upper rack

Height adjustment:

(The dishwasher is delivered with the upper rack in the top position).

The dishwasher is delivered with the upper rack in the top position.

• To lower: pull out the two side handles and gently lower the rack.

• To raise: pull up the two side handles until the rack clicks into place.

• The rack must be level on both sides.

Lower rack

Cutlery basket:

The cutlery basket can be removed to increase available space.

Plate holders:

• May be removed to increase available space.

• To remove: pull the handle up.

• To reposition, simply insert in the

required position (normal or crosswise).