Whirlpool AKR 027/IX/01 User Manual
3gb66020.fm Page 9 Monday, August 26, 2002 3:32 PM
INSTRUCTIONS FOR USE
BEFORE USING THE COOKTOP
INSTALLATION - TECHNICAL INFORMATION FOR THE
INSTALLER
PROTECTING THE ENVIRONMENT
PRECAUTIONS AND GENERAL RECOMMENDATIONS
TROUBLESHOOTING GUIDE
AFTER-SALES SERVICE
9
3gb66020.fm Page 10 Monday, August 26, 2002 3:32 PM
BEFORE USING THE COOKTOP
• To make the most of your new appliance, please read the user instructions carefully and keep them to handy
for future consultation.
INSTALLATION - TECHNICAL INFORMATION FOR THE
INSTALLER
Make sure that the appliance is installed and connected to the
•
electricity supply by a qualified technician in accordance with the
manufacturer’s instructions and in compliance with local
regulations.
Before installation, please read these few hints:
•
The cooktop must be installed into a worktop (20-40 mm thick for an
•
electric hotplate, 30-40 mm for a barbecue and fryer, and 600 mm
deep).
The distance between the lower face of the cooktop and any
•
cupboard or separating panel must be of at least 30 mm.
If the cooktop is to be installed next to a column unit, leave the
•
distance illustrated in the figure.
If a hood or cupboard is installed above the cooktop, leave a
•
minimum distance of 650 mm.
The coatings of the walls of th e unit or appliances near the cooktop
•
must be heat resistant.
Do not install the cooktop near flammable materials (e.g.: curtains).
•
The wall behind the cooktop must be at least 50 mm away.
•
Barbecue and fryer
Electric hotplate
Installation
Cut an opening in the worktop of the dimensions shown in the
•
Product Description Sheet supplied separately.
Stretch gasket
•
overlay the junction edges.
Turn the cooktop upside down and put tabs
•
provided, tightening screws
Please make sure that the tabs are correctly positioned as illustrated.
•
Position the cooktop into the housing.
•
Put tabs
•
•
•
(A)
Tighten screw
Cut off the gasket
10
over the edge of the hole made being careful to
(D)
into the seats
a few turns.
(B)
into place; tooth
until the cooktop is completely secured.
(B)
protruding from the cooktop with a sharp tool.
(D)
of the tabs should fit into the hole.
(C)
(A)
Electric hotplate
Barbecue and fryer
Loading...