Whirlpool ADP 931 WH INSTRUCTION FOR USE

GB

ADP 931

Quick Reference Guide

Further indications are given in the pages to follow and in the user instructions.

Programme selector

Start button

Indicator lamp lit while the dishwasher is operating.
Flashes when a fault occurs.
Switches off at the end of the pr ogramme.

Programme Symbol

and Temperature

Pre-wash

Bio-Eco 50° C

Normal 65° C

1) Values may vary in relation to usage, e.g.: different loads, water temperatu res - above or below 15° C ­as well as water hardness and power supply voltage.

2) Reference programme for Test Institute and energy-label.

2)

Programme selection and

recommended load type

Crockery to be washed later.
Normally or heavily soiled crockery with

dried-on food.
Heavily soiled pans and saucepans.

small compartment large compartment

Place the detergent in the:

--5.00.029

X X 16.0 1.40 86

X X 16.0 1.60 86

1)

Time

(Min.)

Water

(Litres)

Consumption

Normal load

Energy

(kWh)

5019 100 91257

(We reserve the right to make technical modifications)

A

A

C

How to use the dishwasher

1. After loading the dishwasher, cl ose the
door properly and open the water
supply tap.

2. The dishwasher switches on
automatically as soon as the programme
selector knob is turned.

programme indicator lamps will
switch on.

3. Turn the selector knob to select the
desired programme.

corresponding indicator lamp lights

If required, select options

up.

(if supplied).

4. Press the Start button to start the
selected programme.

indicator lamp will light up.

the programmed data cannot be
altered by turning the programme
selector knob.

Once the Start button has been

Note:

pressed, the dishwasher memorises the
last programme selected. This
information remains in the memory even
during interruption of the power supply.

To change the programme
selected, press the Start button
for about 5 seconds. The Start
indicator lamp will switch off.
Select a new programme and
press the Start button.

If the dishwasher is switched off

Note:

during a wash programme, when
switched on again it will resume the
wash cycle from where it was
interrupted.

Only open the dishwasher door if
strictly necessary during a wash
cycle and exercise maximum
caution. Danger of scalding from

5. To indicate the end of the programme,

steam.

the Start indicator lamp switches off
and

the End indicator lamp (if fitted)

switches on

(for about 30 min.)

One of the

The

The Start

Once set,

.

6. Turn the programme selector knob to the
“0” position to switch off the dishwasher
(only after the Start indicator lamp has
switched off).

switch off.

7. Open the door (warning: beware of hot
steam). Unload the lower rack before
the upper one. Close the water tap.

All the indicator lamps

Upper rack

Rack height adjustment:

(The dishwasher is delivered with the upper
rack in the top position).

The rack height can also be changed
when loaded.

Please read the user instructions carefully.

Upper and lower rack

• To lower: pull out the
handles and gently lower the rack.

• To raise: pull up the
until the rack clicks into place.

• The rack must be level on both
sides.

Crockery holders:

• Down:
cups and long-stemmed glasses.

•

Up: plates.

Glass holder:

two

side handles

two

side

Lower rack

Plate holders:

•(A) may be lowered to increase
available space.

Cutlery basket:

• The cutlery basket can be removed to
increase (C) available space.

C