Whirlpool ADP 253 WH, ADP 253 GR INSTRUCTION FOR USE

GB

ADP 253

Quick Reference Guide

Further indications are given in the pages to follow and in the user instructions

Options

Rinse aid level indicator

Add rinse aid.

Salt level indicator

Add regeneration salt; only add regeneration
salt immediately before starting a wash programme.

Programme Symbol

and Temperature

1

2

3

4

5

1) Values may vary in relation to usage e.g.: different loads, water
temperatures - above or below 15° C - or water hardness and power supply voltage, etc.

2) Reference programme for Test Institute and energy-labe l.

Pre-rinse

Normal 65° C

Daily 65° C

Eco 50° C

Rapid 50° C

Crockery to be washed later.

Soiled or heavily soiled crockery.

Soiled crockery, with no dried-on food.

2)

Normally or heavily soiled crockery with dried-on food.

Glasses, lightly soiled crockery.

Programme selection and

recommended load type

Rapid button

Press this button to select a short wash cycle.

50° C button

Press this button to select an eco cycle.

Options

Rapid

50° C

- - - - 4.5 0.10 10

- - X X 20.0 1.70 110

- - - X 16.0 1.64 100

- X X X 20.0 1.44 100

X - - X 16.0 1.30 55

50° C

Place the detergent into the:

compartment

On/Off button

Consumption

Normal load

small

(A)

large

compartment

(B)

Water
(Litre)

Energy

(kWh)

5019 100 93321

(We reserve the right to make technical modifications)

1)

Time

(Min.)

How to use the dishwasher

1. After loading the crockery, close the
dishwasher door properly and open the
water supply tap.

2. Select the desired programme by turning
the selector's knob clockwise: position 1:
“Pre-rinse”; position 2: “Normal”; position
3: “Daily”. To select the “Eco” programme:
turn the selector's knob to position 2 and
press the “50° C” button. To select the
“Rapid” programme: turn the selector's
knob to position 3 and press the “Rapid”
button.

The dishwasher starts automatically as
soon as the On/Off button has been
pressed.

3. Press the On/Off button to switch the
dishwasher on. The indicator lamp
switches on.

To change the selected programme,
press the On/Off button to turn the
dishwasher off and then turn the
selector knob to the desired
programme (if required, select the
optional “50° C” or “Express”
functions by pressing the relevant
buttons). Press the On/off button to
start the newly selected programme.

Note:

if you switch off the dishwasher during
a wash cycle, when switched on again, the
dishwasher resumes the cycle from where it
was interrupted.

Only open the dishwasher door if
strictly necessary during a wash
cycle and exercise maximum caution.
Danger of scalding from steam.

4. The wash programme is over when the
selector's knob is back in the Stop
position.

5. Switch off the dishwasher now by
pressing the On/Off button. All the
indicator lamps switch off.

6. Open the door (warning: beware of hot
steam). Unload the lower rack before the
upper one.

Close the water tap.

Upper rack

Upper and lower rack

Height adjustment must only be
carried out with the basket empty:

• Release the caps of the rack rails by
pushing them outwards sideways.

• Take the rack out and re-insert it using
either the upper or lower roller pairs as
required.

• Close the caps.

• The rack must be level on both
sides.

Crockery holders:

• Down: cups and long-stemmed
glasses.

• Up: plates.

Lower rack

Cutlery basket (A):

• The cutlery basket can be either
inserted or removed to increase
available space, as required.

• If present, the central compartment is
recommended for storing teaspoons.

Plate holders (B) (if available):

Please read the user instructions carefully.