wheelock SP40S Service Manual

Cooper Wheelock, Inc.

273 Branchport Ave
Long Branch, NJ 07740-6899

Tel: [phone]
[phone]
Fax: [phone]

E-mail:
www.cooperwheelock.com

[e-mail]

®

SAFEPATH

AM-SP40S-PMK

Programmed Message Kit Order Form

PLEASE PRINT

PO#________________________________ Date ______________________
Customer Name ________________________________________________________________
Phone _________________________________ Fax _____________________________
Bill To Address _________________________________________________________________
Ship To Address

Contact Person ________________________________________________________________
Shipping Method _______________________________________________________________
End User Name, City & State _____________________________________________________
Intended Application of Product ___________________________________________________
Authorized Signature & Title ______________________________________________________

Note: Cooper Wheelock expressly disclaims all liability for the content, clarity and languages of, and priority level
assigned to, any and all messages. It is essential that you have message content and language sequence and
priority assignments reviewed and approved by qualified legal and safety advisors, qualified representative(s) of
owner(s), and authorities having jurisdiction.

(If different than Bill To Address) ____________________________________________

4 SP40S

Page 1 of 4

Custom Message Content Instructions:

1. Maximum time limit for each Message is 30 seconds. Two tones (code 3 & continuous) for the
messages are already built into sp40s and do not need to be programmed onto the chip. Listed below
are examples of standard message blocks:

Message/Tone # 1, Priority 1 30 seconds

Message/Tone # 2, Priority 2 30 seconds
Message/Tone # 3, Priority 3 30 seconds
Message/Tone # 4, Priority 4 30 seconds
Message/Tone # 5, Priority 5 30 seconds
Message/Tone # 6, Priority 6 30 seconds
Message/Tone # 7, Priority 7 30 seconds
Message/Tone # 8, Priority 8 30 seconds

2. Message segments can be combined into 30-second blocks for a maximum of 240 seconds. This will
result in fewer messages. Listed below is an example of combined 30 second blocks:

Message/Tone # 1, Priority 1 120 seconds

Message/Tone # 2, Priority 2 not available
Message/Tone # 3, Priority 3 not available
Message/Tone # 4, Priority 4 not available
Message/Tone # 5, Priority 5 60 seconds
Message/Tone # 6 Priority 6 not available
Message/Tone # 7 Priority 7 30 seconds
Message/Tone # 8, Priority 8 30 seconds

3. If message and tone requirements exceed the times listed above, contact Technical Support for
assistance – [phone], option 3.

4. If a multi-language message is required, please note the time constraints. In addition, foreign language
audio files may be required to be submitted for the recording.

5. The SP40S has a pre-tones built in; code 3, continuous tone 1k Hz or no tone can be selected via a dip
switch. If another tone is required, it must be specified as part of the message content.

6. If a wave file, CD or cassette is sent in to be programmed onto a voice chip, it needs to be
accompanied with an English translation of the message detailing the assigned input file number.

7. A male voice will be used if voice type is not selected.

8. Please ensure that a contact name and phone number is submitted in case there is a question on
programming content. This can reduce the time it takes to create the custom message chip.

9. The message content will repeat a minimum of 3 rounds automatically when activated.

Page 2 of 4