W box technologies 0E-STROBERPR, 0E-STROBERPC, 0E-STROBERPA, 0E-STROBERPB User Manual
Instructions for 0E-STROBERPA/B/C/R
Rainproof Strobe
Application:
The W Box 0E-STROBERPA/B/C/R strobe is the lowest current
consumption, rainproof and weather resistant strobe in its class. It
operates on 12VDC and draws just 108mA. It’s high impact resistant
lens stands up to normal wear and abuse. The strobe is rated at
62,000 candle power and has an operating life of 50,000 hours of
continuous operation, which is 250 times that of similar models.
0E-STROBERPA/B/C/R can be mounted on a bell box or other
enclosure, including W Box model 0E-STSTSIREN, or mounted directly
to wood or other surface. Two bolts, two nuts and two wood screws
are provided. An adhesive mounting gasket is provided to enhance
waterproong. A rubber ring seals the lens with the base.
Four lens colors are available:
Amber (model 0E-STROBERPA)
Blue (model 0E-STROBERPB)
Clear (model 0E-STROBERPC)
Red (model 0E-STROBERPR)
Product specications:
• Voltage input: 12VDC (9.6 - 14.4)
• Current draw: 108mA
• Strobe output: 62,000 candle power
• Flash rate: 60-100 per minute
• Wire type: Two 20AWG UL listed wire leads, stranded with ends
stripped and tinned
• Housing: High impact resistant thermoplastic
• Operating temperature: -4ºF to 140ºF (-20ºC to 60ºC)
• Relative humidity: 95%
• Dimensions: 3.54 diameter X 3.05”H (90mm dia. X 77mmH)
• Lens colors available: Amber (0E-STROBERPA), Blue (0E-STROBERPB),
Clear (0E-STROBERPC), Red (0E-STROBERPR)
Wiring:
Connect red wire to positive 12VDC (+) and black wire to negative (-).
Observe polarity at all times.
Reverse polarity protection is provided, but polarity should still
be observed at all times.
Installation:
1) Remove lens from base by rmly rotating counter-clockwise. Be
certain to retain rubber ring which seals lens with base.
2) Use knockout holes on base to mount base directly to a bell box or
other enclosure, including W Box model 0E-STSTSIREN, or to mount
directly to wood or other surface. The inner holes align with the
mounting holes on the top of W Box model 0E-STSTSIREN and other
enclosures. The outer knockout holes can be used to mount to a trim
plate that ts a double gang junction box or to a surface of any type.
Any of the knockout holes can be used for direct mounting to wood or
other surface. Two bolts, two nuts and two wood screws are provided
for convenience.
For rain-proof installation, install the adhesive gasket provided
between base and the surface it is being mounted to.
3) Connect wires per wiring instructions.
4) Making certain rubber ring is in place rst, replace lens on base by
turning clockwise. Be certain to rotate lens fully so lens is locked in
place.
Avoid excessive removal and replacement of lens as repetition
may cause wear on rubber ring and degrade sealing
performance.
NOTE: There is no danger of shock from a high voltage charge
while hadling because this model does not utilize components
that store high voltage charges.
Lens
Rubber ring
Base
RAINPROOF STROBE
Adhesive gasket
Mounting surface
or trim plate
(not provided)
Junction box
(not provided,
not required)
Screws/bolts
Lead wires
Loading...