Waldmann RL70E-1xx, RL70CE-1xx Instruction Manual

ENG

Instructions For Use RL70E-1xx, RL70CE-1xx

General

Designated use:

Intended purpose:

This light was developed specially
for use on machines and for out­door use. It is protected against
the ingress of liquids (protection
type IP 67).

The light can be fitted with different
light sources (see also „Technical
data“).

Place of use:

Not suited for rooms subject to
danger of explosion.

The ambient temperature of the
light must not exceed 25°C. Dif­ferent ambient temperatures are
specified on the rating plate of
the light.

Operating mode:

The light is designed for continuous
operation.

Safety instructions:

The light may only be operated in
rooms not subject to explosion
hazards!

The light must be mounted on the
selected wall by means of suit-
able pipe clamps.

Mounting and connection of the
light may only be carried out by a
qualified electrician!

Disconnect the damaged connect­ing cable immediately from the
power supply and have it replaced
by the manufacturer or by a quali­fied electrician.

For lights of international

protection class I, the pro­tective earth conductor must be
connected to the terminal of the
light chassis.

The manufacturer cannot be held liable for damage caused

by using the unit for purposes other than the designated use

or by ignoring safety instructions and warnings.

Abbreviations and symbols:

Attention,
take note of the accompa­nying documents!

Protective earth terminal
(unit of protection class I)

Take note of the disposal
instructions!

VDE Approval

CE
conformity mark

Mounting

The light is mounted by means of
two suitable pipe clamps or directly
at the side part (only in case of side
part type B).

The user has to verify the reliability
when using mounting elements
which have been not proposed by
the manufacturer!

8

ENG

Instructions For Use RL70E-1xx, RL70CE-1xx

Opening the light

Side part type A or B

After loosening the 3 screws on the
connection side of the light (approx.
3-4 turns), the light column can be
removed (see fig. 2a and 2b).

Side part type C

To open the light, turn the outer
rotary ring (connection side) coun­terclockwise while holding the
counterpiece with a straight pin
(see fig. 2c), if necessary.

Important! Clean the seals after
you have detached and reattached
the lateral parts.

Installation

The light is delivered with an inte­grated electronic ballast unit. The
power supply is effected by means
of the built-in terminal strip (see
connection diagram fig. 4).

Optionally the light is delivered
with a lateral connector. For these
lights, the device box is enclosed
in the delivery.

To connect the light, pull the side
part out of the light tube. Pull the
lamp holder slightly out of the light
tube and remove the cover. Then
connect the cable to the terminal
(see fig. 3).

Assembly takes place in reverse
order.

Putting into operation

Before putting the light into opera­tion, the user has to check whether
the mains voltage is identical to the
rated voltage and frequency speci­fied on the rating plate.

Operation

The light is not equipped with
a switch of its own. It is usu­ally switched on/off via an external
switch.

Maintenance and repairs

Disconnect the light from the
mains before carrying out any
maintenance or repair work! This

work may only be carried out by a
qualified electrician.

Only parts approved by the manu­facturer may be used as spare
parts.

Important! Clean the seals after
you have detached and reattached
the lateral parts.

9