Waldmann MINELA Instruction Manual
17
GB Instructions for Use Office Task Light ETL 1 F "MINELA"
Safety instructionsSafety instructions
Danger!
Danger caused by wrong
mounting or handling!
Wrong mounting or handling of
this unit can result in serious injuries or death.
First read these instruc- ¾
tions and, where appropriate, any other instructions and information attached
to the unit!
Please observe the warnings ¾
and notes included in the
instructions and attached to
the unit!
Danger!
This symbol identifies items that
may directly result in serious injuries or death in case of non-observance or wrong handling.
Warning!
This symbol identifies items that
may result in serious injuries or
death in case of non-observance
or wrong handling.
Caution!
This symbol identifies items that
may result in injuries or material
damage in case of non-observance or wrong handling.
Note!
This symbol identifies items that
are of importance for handling
and operation.
18
GB Instructions for Use Office Task Light ETL 1 F "MINELA"
Safety instructions
Danger!
Explosion hazard!
Operating the light in rooms subject to explosion hazards can trigger an explosion.
Caution!
Risk of corrosion!
Operating the light in moist rooms
can result in damage to the light!
Operate in dry rooms not sub- ¾
ject to explosion hazards only!
The manufacturer cannot be held liable for damage caused by using the unit for purposes contrary
to the designated use or by ignoring safety instructions and warnings.
Caution!
Damage caused by
wrong operating unit!
An unsuitable operating unit can
result in destroying the light.
Operate the light with the op- ¾
erating units proposed by the
manufacturer only.
For lights of protection ¾
class II you should ensure
that their metal parts do not
contact other metal parts which
are connected to the protective
earth conductor.
Caution!
Damage caused by
wrong connection!
A wrong mains voltage or polarity
can result in damaging or destroying the light.
The connection must be car- ¾
ried out by a skilled electrician
only!
Before putting the light into ¾
operation, the user has to check
whether the mains voltage is
identical to the rated voltage
specified on the rating plate!
19
GB Instructions for Use Office Task Light ETL 1 F "MINELA"
General
Designated use:
Intended purpose:
Task light - task lights are lights intended to illuminate a single workstation and are used in addition to
general lighting equipment.
Place of use:
Exclusively for dry rooms not subject to explosion hazards.
Operating mode:
The light is designed for continuous operation.
The manufacturer cannot be held liable for damage caused by using the unit for purposes contrary
to the designated use or by ignoring safety instructions and warnings.
Abbreviations and symbols
Safety information!
Important information!
Unit corresponds to international protection class II
(all-insulated)
Observe the disposal
instructions!
The light is suitable for
mounting on normally inflammable surfaces
LED light-emitting diode
VDE approval
ENEC approval
SEV approval
CE
Conformity mark
Loading...