V-Tech VT-RLC User Manual

RLC –

1. Function Introductions

1. The RLC unit is used to connect and co ntrol additional front door e-lock or lights. You
can open the door or light both by the monitor and the additional buttons.

2. Different operation mode can be used. You can manually turn the light on and off, or
select the light-on duration time between 1 minute / 3 min / 5 min / 10 min.

3. All settings are easily done by the DIP switches.

4. Achieve both Light control and Lock control by apply 2 RLCs in the system.

L

2. Necessary Settings on Monitor

To enable the RLC, the following settings on the monitor must be set:
When the monitor is in standby, select and enter MAIN Æ SETUP Æ ADVANCED SET Æ
OTHER DEVICE SET… Æ PASSWORD, to get into the RLC setting page:
Press the item on the screen(RLC LOCK or RLC LAMP) to turn the function on and off.
Then press EXIT to exit out.

Relay Controller User Manual

You can only select one of the two functions when using one RLC, either Light
control or Lock control. 2 RLCs must be used if you need both functions at your
system!

VT-ENG-RLC-V1 090s506

3. RCL Connections for lamps

-1-

4. RCL Connections for Electronic Lock (Power-to-Open)

5. Connections for E-magnetic Lock(Power-off-to-Open)

-2-