VTech LS6226-2 User Manual

User’s manual

Accessory handset for use with VTech models

LS6215/LS6215-2/LS6215-3/ LS6225/LS6225-2/LS6225-3/ LS6225-4/LS6225-5/LS6226-2

w w w.v t e c h p h o n e s . c o m

Model: LS6205

Congratulations

on purchasing your new VTech product. Before using this telephone, please read the Important safety instructions on page 7 of this manual.

This manual has instructions for setup and registration of your new handset. For full instructions on using the handset, see the user’s manual that came with your telephone base.

If you cannot nd your user’s manual, you can view or download it at www.vtechphones.com.

For support, shopping, and everything new at VTech, visit our website at www.vtechphones.com. In Canada, please visit www.vtechcanada.com.

The ENERGY STAR® program (www.energystar.gov) recognizes and encourages the use of products that save energy and help protect our environment. We are proud to mark this product with the ENERGY STAR® label indicating it meets the latest energy

efciency guidelines.

Table of contents

Getting started ................................... 1

Parts checklist ...................................... 1

Battery installation and charging .......... 2

Add and register a handset .................. 3

Replace a handset ............................... 4

Handset layout ..................................... 5

Appendix ............................................. 6

Battery .................................................. 6

Important safety instructions ................ 7

Operating range ................................... 8

Maintenance ......................................... 8

About cordless telephones................... 9

The RBRC® seal ................................... 9

Warranty ............................................. 10

FCC, ACTA and IC regulations .......... 12

Technical specications ..................... 14

Getting started

Parts checklist

Your telephone contains the following items. Save your sales receipt and original packaging in the event warranty service is necessary.

Batte ry compar tm ent c over Batte ry

Handset

To purchase a replacement battery or a power adapter, visit our website at www.vtechphones.com or call 1 (800) 595-9511. In Canada, go to www.vtechcanada.com or call 1 (800) 267-7377.

User’s manu al

Charg er and c harge r adapte r

Getting started

Battery installation and charging

Install the battery as shown below. After installing the battery, you might be able to make and receive short calls. For best performance, charge the handset for at least 16 hours before use. When not in use, place the handset in the telephone base or charger. See page 6 for battery operating times.

Battery indicators Battery status Action

The screen is blank. Battery has no charge

The screen shows

PLACE IN CHARGER

and ashes.

The screen shows LOW BATTERY,

ashes, and the

handset beeps.

The screen shows HANDSET X.

If the battery compartment cover is on the handset, press the indentation

and the handset cannot be used.

Battery has very little charge and the handset cannot be used.

Battery has enough charge to be used for a short time.

Battery is charged. To keep the battery charged,

and slide the cover to remove.

Plug the battery connector securely into the socket inside the handset battery compartment, matching the color-coded label.

Place the battery with the label THIS SIDE UP facing up and the wires inside the battery compartment.

Align the cover at against the battery compartment, then slide it towards

the center of the handset until it clicks into place. Charge the handset by placing it in the telephone base or charger. The

CHARGE light is on when the handset charges.

1 5

Charge until the screen shows LOW BATTERY (at least 10 minutes).

Charge until the screen shows LOW BATTERY (about four minutes).

Charge until the screen shows HANDSET X (about one hour).

place it in the telephone base or charger when not in use.

CHARGE

light

When the screen shows LOW BATTERY, the backlight is off.

• If the handset will not be used for a long time, disconnect and remove the

•

battery to prevent possible leakage.

To purchase replacement batteries, visit our website at www.vtechphones.

•

com or call 1 (800) 595-9511. In Canada, go to www.vtechcanada.com or call 1 (800) 267-7377.

Getting started

Add and register a handset

Each newly purchased handset (LS6205) must be registered to the telephone base (LS6215 or LS6225) before use. When rst purchased, each expansion handset shows NOT REGISTERED.

When rst purchased, each expansion handset shows NOT REGISTERED. You may need to charge the handset before registering to the telephone base. For more details on battery charging, see the table on page 2.

To register a handset:

Place the unregistered handset in the telephone base or charger. If

PRESS FIND HS 4 SEC ON BASE does not appear on the handset screen after a few seconds, remove the handset and place it in the telephone base or charger again.

On the telephone base, press and hold

FIND HANDSET for about four seconds (until the red IN USE light on the telephone base turns on) and then release the button. The handset shows PLEASE WAIT... and it takes up to 60 seconds to complete the registration. The handset shows HANDSET X REGISTERED (X represents the handset number assigned) and you hear a beep when the registration completes.

When the registration is complete, the newly registered handset is assigned the next available handset registration number. For instance, if you already have HANDSET 1 and HANDSET 2, the next registered handset is HANDSET 3.

If the registration fails, the handset shows NOT REGISTERED. To reset the

•

handset, remove the handset from the telephone base or charger and place it back in. Try the registration process again.

You cannot register a handset if any other system handset is in use.

• Only one handset can be registered at a time.

•

+ 12 hidden pages