VIZIO SB3820-C6 Quick Start Guide
VIZIO
QUICK START GUIDE
Model: SB3820-C6
IMPORTANT SAFETY INSTRUCTIONS
Your Unit is designed and manufactured to operate within dened design limits, and misuse may
result in electric shock or re. To prevent your Unit from being damaged, the following rules should
be observed for its installation, use, and maintenance. Please read the following safety instructions
before operating your Unit. Keep these instructions in a safe place for future reference.
• Read these instructions.
• Keep these instructions.
• Heed all warnings.
• Follow all instructions.
• Do not use this apparatus near water.
• Clean only with a dry cloth.
• Do not block any ventilation openings. Install in accordance with the manufacturer’s
instructions.
• Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus
(including ampliers) that produce heat.
• Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has
two blades with one wider than the other. A grounding type plug has two blades and a third
grounding prong. The wide blade or the third prong are provided for your safety. If the provided
plug does not t into your outlet, consult an electrician for replacement of the obsolete outlet.
• Protect the power cord from being walked on or pinched, particularly at plugs, convenience
receptacles, and the point where they exit from the apparatus.
• Only use attachments/accessories specied by the manufacturer.
• Use only with the cart, stand, tripod, bracket, or table specied by the manufacturer,
or sold with the apparatus. When a cart is used, use caution when moving the cart/
apparatus combination to avoid injury from tip-over.
• Unplug this apparatus during lightning storms or when unused for long periods of time.
• Refer all servicing to qualied service personnel. Servicing is required when the apparatus has
been damaged in any way, such as when the power supply cord or plug is damaged, liquid has
been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain
or moisture, does not operate normally, or has been dropped.
• To reduce the risk of electric shock or component damage, switch o the power before
connecting other components to your Unit.
• Unplug the power cord before cleaning your Unit. A damp cloth is sucient for cleaning. Do not
use a liquid or a spray cleaner on your Unit. Do not use abrasive cleaners.
• Always use the accessories recommended by the manufacturer to insure compatibility.
• When moving your Unit from an area of low temperature to an area of high temperature,
condensation may form in the housing. Wait before turning on your Unit to avoid causing re,
electric shock, or component damage.
• Slots and openings in the back and bottom of the cabinet are provided for ventilation. To ensure
reliable operation of your Unit and to protect it from overheating, be sure these openings
are not blocked or covered. Do not place your Unit in a bookcase or cabinet unless proper
ventilation is provided.
• Never push any object into the slots and openings on your Unit enclosure. Do not place any
objects on the top of your Unit. Doing so could short circuit parts causing a re or electric shock.
Never spill liquids on your Unit.
• When connected to a power outlet, power is always owing into your Unit. To totally disconnect
power, unplug the power cord.
• Do not overload power strips and extension cords. Overloading can result in re or
electric shock.
• The wall socket should be located near your Unit and be easily accessible
• Keep your Unit away from moisture. Do not expose your Unit to rain or moisture. If water
penetrates into your Unit, unplug the power cord and contact your dealer. Continuous use in
this case may result in re or electric shock.
• Do not use your Unit if any abnormality occurs. If any smoke or odor becomes apparent,
unplug the power cord and contact your dealer immediately. Do not try to repair your
unit yourself.
• Avoid using dropped or damaged appliances. If your Unit is dropped and the housing
is damaged, the internal components may function abnormally. Unplug the power cord
immediately and contact your dealer for repair. Continued use of your Unit may cause re or
electric shock.
• Do not install your Unit in an area with heavy dust or high humidity. Operating your Unit in
environments with heavy dust or high humidity may cause re or electric shock.
• Ensure that the power cord and any other cables are unplugged before moving your Unit.
• When unplugging your Unit, hold the power plug, not the cord. Pulling on the power cord may
damage the wires inside the cord and cause re or electric shock. When your Unit will not be
used for an extended period of time, unplug the power cord.
• To reduce risk of electric shock, do not touch the connector with wet hands.
• Insert the remote control batteries in accordance with instructions. Incorrect polarity may
cause the battery to leak which can damage the remote control or injure the operator.
• See the important note and rating located on the back of the unit.
• WARNING - This equipment is not waterproof. To prevent a re or shock hazard, do not place
any container lled with liquid near the equipment (such as a vase or ower pot) or expose it
to dripping, splashing, rain, or moisture.
• CAUTION - Danger of explosion or re if batteries are mistreated. Replace only with the same
or specied type.
• Do not leave the batteries exposed to direct sunlight for a long period of time with doors and
windows closed. Do not disassemble the batteries or dispose of it in re.
• Where the MAINS plug or appliance coupler is used as the disconnect device, the disconnect
device shall remain readily operable.
WARNING: To reduce the risk of re or electric shock, do not expose this apparatus to rain or moisture.
CAUTION
RISK OF ELECTRIC
SHOCK DO NOT OPEN
The lighting ash with arrowhead symbol within an equilateral triangle is intended to
alert the user to the presence of not isolated dangerous voltage within the product
that may be sucient magnitude to constitute a risk of shock to persons.
The exclamation point within an equilateral triangle is intended to alert the user
to the presence of important operating and servicing instructions in the literature
accompanying the appliance.
Warning: This equipment is a Class II or double insulated electrical appliance. It
has been designed in such a way that it does not require a safety connection
to electrical earth.
Explanation of WARNING symbols:
TABLE OF CONTENTS
Package Contents ................................................................... 4
Controls & Connections ......................................................... 5
First-Time Setup...................................................................... 7
Using the Remote ................................................................... 11
LED Indicators ......................................................................... 12
Bluetooth Pairing .................................................................... 14
Using Bluetooth mode ........................................................... 15
Advanced Setup ...................................................................... 16
Connecting a Subwoofer ...................................................... 17
Using Button Combinations .................................................. 18
Wall-Mounting the Sound Bar ............................................... 19
One-Year Limited Warranty ................................................... 26
Legal & Compliance ................................................................ 27
PACKAGE CONTENTS
High Denition Sound Bar
Power Cable
2 x Sound Bar
Wall Mount
Brackets
Coaxial Audio
Cable
Mount Screws
(Size: M4 x 10mm)
Remote Control with
2 x AAA Batteries
Stereo RCA
to 3.5mm
Audio Cable
2 x Wall
4
This Quick
Start Guide
Digital Optical
Cable
Wall Mount
Template
CONTROLS & CONNECTIONS
Back of Sound Bar
Power Port
* Supports.WAVleformatplaybackonly.
SUB OUT
Subwoofer Out
USB* (6)
USB In
OPTICAL (4)
Digital Optical
Audio In
DIGITAL (3)
Coaxial In
5
AUX (1)
Analog Audio In
(Stereo RCA)
AUX (2)
Analog Audio In
(Stereo 3.5mm)
Top of Sound Bar
Bluetooth Input Hold to pair.
(See ‘Bluetooth Pairing’ for more information.)
Volume Increase or decrease the loudness
of the audio.
Input Press to change the audio source.
Power Press to turn soundbar on or o.
6
FIRST-TIME SETUP
CHOOSE ONE CABLE
1
GOOD
OR
BETTER
DIGITAL OPTICAL
CABLE
†
BETTER
AND CONNECT
IT TO YOUR TV
Back of Sound Bar
DIGITAL COAXIAL
CABLE
†‡
BETTER
3.5MM TO
RCA CABLE
GOOD
* Not all TVs have the audio outputs shown above. To connect the
Sound Bar directly to your other devices (Blu-Ray player, game
system, etc.) see your device’s user manual.
† When using either of the Digital Inputs, if there is no audio: (A)
try setting the TV output to PCM or (B) Connect directly to your
Blu-ray/other source, some TVs do not pass through digital audio.
‡ Cable not included.
3.5MM TO
RCA CABLE
GOOD
2
Connect the power cable to the
Sound Bar AC IN as shown.
Plug the power cable into an
electrical outlet.
3
For the best surround sound experience, position the Sound Bar as shown.
The Sound Bar should be close to ear level.
Sound Bar is centered
below the TV.
Loading...