Vizio S3851w-D4 User Manual

0 (0)

VIZIO

QUICK START GUIDE

Model: S3851w-D4

IMPORTANT SAFETY INSTRUCTIONS

Your Unit is designed and manufactured to operate within defined design limits, and misuse may result in electric shock or fire.To prevent your Unit from being damaged, the following rules should be observed for its installation, use, and maintenance. Please read the following safety instructions before operating your Unit. Keep these instructions in a safe place for future reference.

Read these instructions.

Keep these instructions.

Heed all warnings.

Follow all instructions.

Do not use this apparatus near water.

Clean only with a dry cloth.

Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.

Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.

Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong.The wide blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.

Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.

Only use attachments/accessories specified by the manufacturer.

• Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.

Unplug this apparatus during lightning storms or when unused for long periods of time.

Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as when the power supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.

To reduce the risk of electric shock or component damage, switch off the power before connecting other components to your Unit.

Unplug the power cord before cleaning your Unit. A damp cloth is sufficient for cleaning. Do not use a liquid or a spray cleaner on your Unit. Do not use abrasive cleaners.

Always use the accessories recommended by the manufacturer to insure compatibility.

When moving your Unit from an area of low temperature to an area of high temperature, condensation may form in the housing. Wait before turning on your Unit to avoid causing fire, electric shock, or component damage.

Slots and openings in the back and bottom of the cabinet are provided for ventilation.To ensure reliable operation of your Unit and to protect it from overheating, be sure these openings are not blocked or

covered. Do not place your Unit in a bookcase or cabinet unless proper ventilation is provided.

Never push any object into the slots and openings on your Unit enclosure. Do not place any objects on the top of your Unit. Doing so could short circuit parts causing a fire or electric shock. Never spill liquids on your Unit.

The power cord must be replaced when using different voltage than the voltage specified. For more information, contact your dealer.

When connected to a power outlet, power is always flowing into your Unit.To totally disconnect power, unplug the power cord.

The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the H user to the presence of un-isolated, dangerous voltage within your Unit that may be of sufficient magnitude to constitute a risk of electric shock to persons.

The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and servicing instructions in the literature accompanying your Unit.

• Do not overload power strips and extension cords. Overloading can result in fire or electric shock.

• The wall socket should be located near your Unit and be easily accessible

Keep your Unit away from moisture. Do not expose your Unit to rain or moisture. If water penetrates into your Unit, unplug the power cord and contact your dealer. Continuous use in this case may result in fire or electric shock.

Do not use your Unit if any abnormality occurs. If any smoke or odor becomes apparent, unplug the power cord and contact your dealer immediately. Do not try to repair your Unit yourself.

Avoid using dropped or damaged appliances. If your Unit is dropped and the housing is damaged, the internal components may function abnormally. Unplug the power cord immediately and contact your dealer for repair. Continued use of your Unit may cause fire or electric shock.

Do not install your Unit in an area with heavy dust or high humidity. Operating your Unit in environments with heavy dust or high humidity may cause fire or electric shock.

Ensure that the power cord and any other cables are unplugged before moving your Unit.

When unplugging your Unit, hold the power plug, not the cord. Pulling on the power cord may damage the wires inside the cord and cause fire or electric shock. When your Unit will not be used for an extended period of time, unplug the power cord.

To reduce risk of electric shock, do not touch the connector with wet hands.

Insert the remote control battery in accordance with instructions. Incorrect polarity may cause the battery to leak which can damage the remote control or injure the operator.

See the important note and rating located on the bottom of the unit.

WARNING - This equipment is not waterproof.To prevent a fire or shock hazard, do not place any container filled with liquid near the equipment (such as a vase or flower pot) or expose it to dripping, splashing, rain, or moisture.

• CAUTION - Danger of explosion or fire if battery is mistreated. Replace only with the same or specified type.

Do not leave the battery exposed to direct sunlight for a long period of time with doors and windows closed. Do not disassemble the battery or dispose of it in fire.

Disconnect the mains plug to shut off when you experience trouble or the device is not in use.The mains plug shall remain readily operable.

When wall mounting, be sure that the mounting surface is strong enough to bear the weight of the Sound Bar.

TABLE OF CONTENTS

 

Package Contents...............................................................

4

Controls & Connections......................................................

5

First-Time Setup....................................................................

8

Using the Remote................................................................

14

Adjusting Sound Bar Settings..............................................

15

Programming the Sound Bar..............................................

18

Resetting to Factory Default Settings..................................

19

Re-linking the Subwoofer with the Sound Bar....................

20

Bluetooth Pairing.................................................................

22

Using Bluetooth Mode.........................................................

23

Advanced Setup.................................................................

24

Wall Mounting the Sound Bar.............................................

26

Wall Mounting the Satellite Speakers.................................

28

Using Button Combinations................................................

29

Help & Troubleshooting.......................................................

33

One-Year Limited Warranty..................................................

34

Legal & Compliance...........................................................

35

PACKAGE CONTENTS

VIZ IO

High Definition Sound Bar with

2 x Satellite Speakers

Remote Control

This Quick

Wireless Subwoofer

 

with Batteries

Start Guide

Digital Optical

Stereo RCA to 3.5mm

Coaxial Audio

2 x Satellite Speaker

2 x Power

Cable

Audio Cable

Cable

Audio Cables

Cables

2 x Sound Bar Wall

2 x Satellite Wall

4 x Wall

Wall Mount

4 x Velcro

Mount Brackets

Mount Brackets

Mount Screws

Template

Cable Ties

 

 

(Size: M4 x 10)

 

 

4

CONTROLS & CONNECTIONS

Back of Sound Bar

DIGITAL (3)

OPTICAL (4)

Power Port

(Optical 4) Digital Optical Audio In

(Digital 3) Coaxial In

USB (5)

(USB 5) USB Port

(Aux 2)

Analog Audio In

(Aux 1)

Analog Audio In

5

Back of Sound Bar

Control Buttons are located here

Power

Input

Bluetooth Input

(Hold to force pair, See Bluetooth Pairing on page 22)

Volume Up/Down

6

Back of Subwoofer

Back of Satellite Speaker

Pairing Button

 

LED Indicator

 

Satellite Speaker

Satellite Speaker Port

(Connects to Subwoofer)

Ports

 

(Connects to Speakers)

 

Power Switch

Power Port

7

FIRST-TIME SETUP

1 Connect one of the included cables to ONE TV audio output as shown.*

DIGITAL (3)

OPTICAL (4)

USB (5)

BETTER

BETTER

GOOD

GOOD

DIGITAL OPTICAL

DIGITAL COAXIAL

3.5MM TO

3.5MM TO

CABLE**

CABLE**

RCA CABLE

RCA CABLE

CHOOSE ONE CABLE:

BETTER

GOOD

AND CONNECT IT TO YOUR TV

*Not all TVs have the audio outputs shown above. To connect the Sound Bar directly

8

**When using either of the Digital Inputs, if there is no audio: (A) try setting the TV

to your other devices (Blu-ray player, game system, etc) see your device’s user manual.

output to PCM or (B) Connect directly to your Blu-ray/other source, some TVs do not

 

 

pass through digital audio.

2

DIGITAL (3)

OPTICAL (4)

Connect a Power Cable to the Sound Bar.

3

Plug the Power Cable into a Power Outlet.

9

Vizio S3851w-D4 User Manual

4

Connected the Satellite Speakers to the Subwoofer

using the included Satellite Speaker Audio Cables.

BACK OF SUBWOOFER

BACK OF SATELLITE SPEAKERS

 

Match the color coded speaker cable to the matching speaker port.

10

BACK OF SUBWOOFER

5

Connect a Power Cable to the Subwoofer.

6

Plug the Power Cable into a power outlet.

7

Flip the Power Switch into the On position.

11

Loading...
+ 25 hidden pages