Your Unit is designed and manufactured to operate within dened design limits, and misuse may result in electric shock or re. To prevent your Unit
from being damaged, the following rules should be observed for its installation, use, and maintenance. Please read the following safety instructions
before operating your Unit. Keep these instructions in a safe place for future reference.
• Read these instructions.
• Keep these instructions.
• Heed all warnings.
• Follow all instructions.
• Do not use this apparatus near water.
• Clean only with a dry cloth.
• Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
• Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including ampliers) that produce heat.
• Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A
grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. If the provided
plug does not t into your outlet, consult an electrician for replacement of the obsolete outlet.
• Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point where they exit from the
apparatus.
• Only use attachments/accessories specied by the manufacturer.
• Use only with the cart, stand, tripod, bracket, or table specied by the manufacturer, or sold with the apparatus. When a cart is used,
use caution when moving the cart/apparatus combination to avoid injury from tip-over.
• Unplug this apparatus during lightning storms or when unused for long periods of time.
• Refer all servicing to qualied service personnel. Servicing is required when the apparatus has been damaged in any way, such as when the power
supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or
moisture, does not operate normally, or has been dropped.
• To reduce the risk of electric shock or component damage, switch o the power before connecting other components to your Unit.
• Unplug the power cord before cleaning your Unit. A damp cloth is sucient for cleaning. Do not use a liquid or a spray cleaner on your Unit. Do not
use abrasive cleaners.
• Always use the accessories recommended by the manufacturer to insure compatibility.
• When moving your Unit from an area of low temperature to an area of high temperature, condensation may form in the housing. Wait before
turning on your Unit to avoid causing re, electric shock, or component damage.
• Slots and openings in the back and bottom of the cabinet are provided for ventilation. To ensure reliable operation of your Unit and to protect it
from overheating, be sure these openings are not blocked or covered. Do not place your Unit in a bookcase or cabinet unless proper ventilation is
provided.
• Never push any object into the slots and openings on your Unit enclosure. Do not place any objects on the top of your Unit. Doing so could short
circuit parts causing a re or electric shock. Never spill liquids on your Unit.
• Never use the subwoofer in the upright, vertical position without installing the legs
• Do not block the subwoofer ports. Allow for 1-2 inches of space around all sides for ventilation.
• WARNING: Exposure to loud sounds can damage your hearing causing hearing loss and tinnitus (ringing or buzzing in the ears). With continued
English - ii
exposure to loud noises, ears may become accustomed to the sound level, which may result in permanent damage to hearing without any noticeable
discomfort.
• When connected to a power outlet, power is always owing into your Unit. To totally disconnect power, unplug the power cord.
• Do not overload power strips and extension cords. Overloading can result in re or
electric shock.
• The wall socket should be located near your Unit and be easily accessible
• Keep your Unit away from moisture. Do not expose your Unit to rain or moisture. If water penetrates into your Unit, unplug the power cord and
contact your dealer. Continuous use in this case may result in re or electric shock.
• Do not use your Unit if any abnormality occurs. If any smoke or odor becomes apparent, unplug the power cord and contact your dealer
immediately. Do not try to repair your
unit yourself.
• Avoid using dropped or damaged appliances. If your Unit is dropped and the housing is damaged, the internal components may function abnormally.
Unplug the power cord immediately and contact your dealer for repair. Continued use of your Unit may cause re or electric shock.
• Do not install your Unit in an area with heavy dust or high humidity. Operating your Unit in environments with heavy dust or high humidity may
cause re or electric shock.
• Ensure that the power cord and any other cables are unplugged before moving your Unit.
• When unplugging your Unit, hold the power plug, not the cord. Pulling on the power cord may damage the wires inside the cord and cause re or
electric shock. When your Unit will not be used for an extended period of time, unplug the power cord.
• To reduce risk of electric shock, do not touch the connector with wet hands.
• Insert the remote control batteries in accordance with instructions. Incorrect polarity may cause the battery to leak which can damage the remote
control or injure the operator.
• See the important note and rating located on the back of the unit.
• WARNING - This equipment is not waterproof. To prevent a re or shock hazard, do not place any container lled with liquid near the equipment
(such as a vase or ower pot) or expose it to dripping, splashing, rain, or moisture.
• CAUTION - Danger of explosion or re if batteries are mistreated. Replace only with the same or specied type.
• Do not leave the batteries exposed to direct sunlight for a long period of time with doors and windows closed. Do not disassemble the batteries or
dispose of it in re.
• Where the MAINS plug or appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable.
• No naked ame sources, such as lighted candles, should be placed on the apparatus.
• The unit is intended for use in moderate and tropic climates.
WARNING: To reduce the risk of re or electric shock, do not expose this apparatus to rain or moisture.
CAUTION
RISK OF ELECTRIC
SHOCK DO NOT OPEN
The lighting ash with arrowhead symbol within
an equilateral triangle is intended to alert the user
to the presence of not isolated dangerous voltage
within the product that may be sucient magnitude
to constitute a risk of shock to persons.
The exclamation point within an equilateral triangle
is intended to alert the user to the presence of
important operating and servicing instructions in
the literature accompanying the appliance.
Warning: This equipment is a Class II or double
insulated electrical appliance. It has been designed
LEAVE THIS SPACE BETWEEN THE SOUND BAR AND YOUR TV / LAISSEZ CET ESPACE ENTRE LA BARRE DE SON ET VOTRE TÉLÉVISEUR / DEJE ESTE ESPACIO ENTRE LA BARRA DE SONIDO Y EL TELEVISOR
Center Line / Ligne Centrale / Línea Central
27.36"/ 69,50 cm
WALL MOUNTING TEMPLATE / MODÈLE DE SUPPORT MURAL / PLANTILLA PARA MONTAJE EN LA PARED
MARK HERE
APPOSEZ UNE MARQUE ICI
MARQUE AQUÍ
VIZIO Sound Bar
Stereo RCA to
3.5mm Audio Cable
2 x Wall
Mount Brackets
(Sound Bar)
Coaxial Audio
Cable
MARK HERE
APPOSEZ UNE MARQUE ICI
MARQUE AQUÍ
Wall Mount Template
Wireless Subwoofer
Remote Control
with 2x AAA Batteries
2 x Power Cables3.5mm to 3.5mm
Audio Cable
MARK HERE
APPOSEZ UNE MARQUE ICI
MARQUE AQUÍ
2 x Wall
Mount Screws
Quick Start Guide
QUICK START GUIDE
Model: SB3621n-E8
VIZIO Sound Bar
Digital Optical
Cable
English - 5
CONTROLS & CONNECTIONS
71-S3621N-TYPB3
116.5mm
71-S3621N-TYPB3
116.5mm
USB*
USB In
Analog Audio In (Stereo 3.5mm)
English - 6
AUX
Back of Sound Bar
Power Port
* Supports .WAV le format playback only.
116.5mm
116.5mm
DIGITAL
Coaxial In
OPTICAL
Digital Optical Audio In
English - 7
Top of
Sound Barr
Power Press to turn
soundbar on or o.
Input Press to change
the audio source.
Bluetooth Input Hold to pair.
(See ‘Bluetooth Audio Pairing’ for
more information.)
Volume Increase or decrease the
loudness of the audio.
English - 8
Back of Subwoofer
Power Port
Pairing Button
LED Indicator
Power Button
116.5mm
FIRST-TIME SETUP
1
CHOOSE ONE CABLE
Back of Sound Bar
AND CONNECT
IT TO YOUR TV
DIGITAL OPTICAL
CABLE
†
BETTER
DIGITAL COAXIAL
CABLE
†
BETTER
* Not all TVs have the audio outputs shown above. To con-
nect the Sound Bar directly to your other devices (Blu-Ray
player, game system, etc.) see your device’s user manual.
† When using either of the Digital Inputs, if there is no
audio: (A) try setting the TV output to PCM or (B) Connect
directly to your Blu-ray/other source, some TVs do not
pass through digital audio.
English - 9
71-S3621N-TYPB3
116.5mm
English - 10
Connect the power cable to the sound bar AC
IN as shown.
2
Plug the power cable into an electrical outlet.
Back of Subwoofer
3
Connect the power cable to the Subwoofer
AC IN as shown.
Plug the power cable into an electrical outlet
and press the power button.
The subwoofer should automatically power
on when plugged in.
English - 11
Loading...
+ 23 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.