Vivotek AW-IHT-0100, AW-IHU-0100 Installation Guide

AW-IHT-0100 Industrial Gigabit PoE Injector
AW-IHU-0100 Industrial Gigabit UPoE Injector

Quick Installation Guide

INTRODUCTION

Model Description

AW-IHT-0100 Standard 802.3af/at 15.4/30W output
AW-IHU-0100 60W output, selectable Mode A and Mode B. 802.3af/at, PoE+

PACKAGE CONTENTS

* 1x PoE injector * 1x DIN rail bracket * 2x wall mount brackets
* 1x Quick Installation Guide * 1x 5-pin terminal block

IMPORTANT:

1. Use CAT5 or 5e UTP/STP cables.

2. Always shut down the power source before connecting power wires.

CONNECTION

LEDs & DIP Switch

PW1PW2

PoE

Non-PoE Switch

AW-IHU-0100AW-IHT-0100

PW1PW2

Mode A

Mode B

4 Pair

4P

2P

B

A

at

HI

Res

Res.

P+D OUT

48 ~ 56V DC

-

Data IN

+-+

Chassis Ground

The recommended DIP switch setting for AW-IHU-0100:
4P, Mode A, at.

DIP switch denitions:

2P 2 pair 30W
4P 4 pair 60W (default)
Mode A Mode A End-span (#1, 2, 3, 6 pins in use) (default)
Mode B Mode B Mid-Span (#4, 5, 7, 8 pins in use)
HI High power 36W
at IEEE 802.3at 30W (default)
Res Reserved (default)
Res. Reserved.

LED denitions:

PW1 Green ON: power good; OFF: power failed.
PW2 Green ON: power good; OFF: power failed.
Mode A End span PD detected (on AW-IHU-0100 only)
Mode B Mid span PD detected (on AW-IHU-0100 only)
4 Pair ON - 60 PSE active (on AW-IHU-0100 only)

OFF - 30W PSE active.

PoE ON: PoE PD detected (on AW-IHT-0100 only)

All specications are subject to change without noice.

Copyright © 2015 VIVOTEK INC. All rights reserved.

VIVOTEK INC.

6F, No.192, Lien-Cheng Rd., Chung-Ho, New Taipei City, 235, Taiwan, R.O.C.

|T: [phone]|F: [phone]| E: [e-mail]

VIVOTEK USA, INC.

2050 Ringwood Avenue, San Jose, CA 95131

|T: 408-773-8686| F: 408-773-8298| E: [e-mail]

VIVOTEK Europe

Randstad 22-133, 1316BW Almere, The Netherlands

T: [phone] E: [e-mail]