Page 1
Installation
GUIDE
3 SERIES
French Door Refrigeration (RVRF336 Series)
Side Trim and Top Grille Kit
GKRVRF1SS
STKRVRFSS
Page 2
Parts included in
GKRVRFSS Top Grille Kit
Left Shim
Trim
Parts included in
STKVRFSS Top Grille Kit
Right Shim
Trim
Grille
Left
Spacer
Right
Spacer
Screws (4)
For installing side spacers
Washers (2)
Installation - GKRVRFSS (Top Grille without side trim)
1
2
step
B
Left Side
Trim
Right Side
Trim
Alcohol Swabs (2)
Alcohol Swab
Alcohol Swab
3
Side View
Grille
These
surfaces
must be
Door
flush
Attach spacers, included in the kit, to the
grille assembly with four screws. DO NOT
install spacers if installing the side trim.
4
Use the two inner hole locations to
properly align the grille.
Remove plastic caps from the top hinges
by removing (3) 1/4” hex head screws. Save
these screws to replace plastic caps.
5
Place plastic caps back on top of hinges
and located exisiting holes. Insert screws
making sure the grille is centered.
Align and position grille on top of unit
so that the face of the grille and the face
of the door are ush.
6
Use washer when replacing screw in
rear hole of plastic cap. Tighten all
hex screws
2
Page 3
Installation - GKRVRFSS and STKVRFSS (Top Grille and Side Trim)
1
1
Side trim can be installed after attaching the grille assembly without the side spacers.
1
Before installing the side
trim, install the grille
assembly without the side
spacers. Use alcohol swabs
step
to clean areas of refrigerator
cabinet and inside of side
trim to ensure adhesive
backing adheres to cabinet
and side trim.
3
2
2
2
71-7/8”
(182.6 cm)
Raise the unit up until the measurement from the
oor to the top of the grille assembly is 71-7/8
inches.
4
2
2
Shim trim has adhesive backing on both sides. Remove adhesive
backing on refrigerator side only. Fit the shim trim to the front of
the unit rst. With center hinge, the shim trim will have a cutout.
Use the cutout to locate the height of the shim trim.
complete
Remove adhesive backing for the side trim. Locate
the top of the side trim with the top of the grille
assembly. Press the side trim into the refrigerator
cabinet at the center location.
Speci cations
Freestanding Refrigerators
Description RVRF336*
Overall height with grille 71-7/8” (182.6 cm)
Cutout height with grille 72” (182.9 cm)
3
Page 4
Viking Range, LLC
111 Front Street
Greenwood, Mississippi 38930
(662) 455-1200
For product information, call 1-888-845-4641
or visit our web site at vikingrange.com in the US or brigade.ca in Canada
057682-000B EN (091217)
Loading...