Velleman WB014 User Manual [en, de, es, fr]
W
L
U
O
WSU
UGNMB
M
U
L
R
E
W
L
O
E
G
E
0
E
R
T
A
5
O
T
ÉC
A
L
R
W
3
P
E
O
W
6
5
0
0
A
0
7
7
W
m
1
B01
F
AT PAN
M
UURBE
S
PPORT
S
PORTE
ANDHA
PORTE
4 -
EL WAL
GEL VO
MURAL
DE PAR
TERUN
DE PAR
B01
SUPP
R FLA
POUR
D PAR
FÜR F
DE EC
-
RT 10"-
SCREEN
RANS
PANTA
ATSCR
à PLAN
B01
0" / 2
S 10"-3
LATS 1
LLA PL
EN 10"-
10"-3
-75cm
"/ 25-
"-30"/
NA 10"-
30"/ 25
" / 25-
5cm
25-75c
30"/ 25
-75cm
5cm
-75cm
SER MAN
EBRUIKE
OTICE D’
ANUAL D
EDIENUN
ANUAL D
WB
UAL
SHANDL
MPLOI
EL USUA
GSANLEI
O UTILIZ
14
IO
UNG
DOR
IDING
4
5
6
8
9
11
B01
6
B0
5
REV. 01
WB014 - WB015 - WB016 Rev. 01
1a
1b
2 3
Figure 1
29/04/2011 ©Velleman nv
2
WB014 - WB015 - WB016 Rev. 01
4
5
6
Figure 2
29/04/2011 ©Velleman nv
3
WB014 - WB015 - WB016 Rev. 01
User manual
1. Introduction
Thank you for choosing Velleman! Please read the manual thoroughly before bringing this device into
service. If the device was damaged in transit, do not install or use it and contact your dealer.
2. Safety Instructions
• Damage caused by disregard of certain guidelines in this manual is not covered by the warranty
and the dealer will not accept responsibility for any ensuing defects or problems.
• Damage caused by user modifications to the device is not covered by the warranty.
• Only use the device for its intended purpose. Using the device in an unauthorised way will void the
warranty.
• Check the contents prior to assembly. Use proper tools and never use defective or deformed
parts as an improper installation may cause serious injury.
• Any included hardware is for mounting on solid brick, concrete or hard wood battens.
When mounting on wood, do not use any concrete anchors. Do not use any included hardware
for mounting on steel. If uncertain about the nature of the wall or mounting techniques, please
consult an expert.
• Respect the product’s max. load specifications. Protect this device from shocks and abuse and
avoid brute force when operating. Check the installation on a bimonthly basis.
• An adequate mounting is essential and falls outside the responsibility of Velleman Components
nv. Respect all installation and operating directions of the device to be mounted/installed
(LCD/plasma display).
• Only use the device at an indoor location, protected from rain, moisture, splashing and dripping
liquids. Make sure the chosen location spot is able to support the weight of the bracket and
screen.
• Keep fingers away from articulations to avoid injury. Keep the device out of reach of children and
unauthorized users at all times.
3. General Guidelines
Refer to the Velleman® Service and Quality Warranty on the last pages of this manual.
4. Features
• for LCD TV
• easy installation
• in accordance with VESA standard 75/100mm & 100/100mm
• comes with all necessary plugs and screws for assembly and mounting
5. Installation
Refer to the illustrations on page 2 and page 3 of this manual.
1) Use the wall mounting bracket to determine and indicate the position of the mounting holes.
1a) When mounting on a brick or concrete wall, drill holes size Ø8mm, at least 50mm deep at the
indicated positions and insert anchors [H]. Fix the wall mounting bracket against the wall
using 4 screws [G]. Mount the included hook [I] as indicated in the illustration on page 2.
1b) When mounting on a wooden wall or wall support, drill holes size Ø3mm, at least 50mm deep
at the indicated positions. Make sure all the holes are blind holes. Fix the wall mounting
bracket against the wall using 4 screws [G]. Mount the include hook [I] as indicated in the
illustration on page 2.
2) Close the bottom cover and slide the cable guides top-down into the foreseen openings in the
mounting bracket.
3) Slide the bracket arm under an angle into the wall mounting bracket and push it down until a
click is heard. The bottom part must rest on the hook [I]. Close the top cover.
4) Mount the TV mounting bracket on the back of the TV, with the hook facing up (top edge of the
TV). Depending on the TV screen, use screws [C], [D], [E] or [F].
5) Hook the TV mounting bracket over the wall mounting bracket and secure it with two screws
[J] and hex wrench [A].
6) Hold the TV-screen in the desired position and secure it by tightening the 3 hex screws at the
end of the bracket arm using hex wrench [B].
29/04/2011 ©Velleman nv
4
WB014 - WB015 - WB016 Rev. 01
6. Technical specifications
WB014 WB015 WB016
LCD/plasma size 10"-30" / 25-75cm
max. load 15kg / 33lbs
TV to wall (mm)
rotation
dimensions
weight 1.1kg 1.1kg 1.65kg
Use this device with original accessories only. Velleman nv cannot be held responsible in
the event of damage or injury resulted from (incorrect) use of this device.
For more info concerning this product and the latest version of this user manual, please
visit our website www.velleman.eu
The information in this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
This manual is copyrighted. The copyright to this manual is owned by Velleman nv. All worldwide rights reserved. No
part of this manual may be copied, reproduced, translated or reduced to any electronic medium or otherwise without the prior
written consent of the copyright holder.
plate 180° left/right – 60° up/down
base 180° left/right
plate 115 x 115mm
base 200 x 75 x 35mm
arm 60 + 80mm 180 + 80mm 180 + 180 + 80mm
min. 83
max. 245
.
min. 128
max. 308
min. 128
max. 488
Gebruikershandleiding
1. Inleiding
Dank u voor uw aankoop! Lees deze handleiding grondig voor u het toestel in gebruik neemt. Werd
het toestel beschadigd tijdens het transport, installeer het dan niet en raadpleeg uw dealer.
2. Veiligheidsinstructies
• De garantie geldt niet voor schade door het negeren van bepaalde richtlijnen in deze handleiding
en uw dealer zal de verantwoordelijkheid afwijzen voor defecten of problemen die hier
rechtstreeks verband mee houden.
• Schade door wijzigingen die de gebruiker heeft aangebracht valt niet onder de garantie.
• Gebruik het toestel enkel waarvoor het gemaakt is. Bij onoordeelkundig gebruik vervalt de
garantie.
• Gebruik geschikt gereedschap dat beschadigd of vervormd is.
• De meegeleverde pluggen en schroeven zijn enkel geschikt voor montage op baksteen, beton of
wanden in hardhout. Gebruik geen nylon pluggen voor beton bij montage op houten wanden of
staal. Neem contact op met een technicus in geval van twijfel.
• Overschrijd nooit de maximale draagkracht van de beugel. Bescherm de beugel tegen schokken.
Vermijd brute kracht tijdens de bediening. Controleer de beugel elke twee maanden.
• De installatie valt volledig buiten de verantwoordelijkheid van Velleman Components nv. Volg de
installatie- en gebruikersinstructies van zowel de beugel als het monteren toestel (lcd- of
plasmascherm) zorgvuldig na.
• De beugel is enkel geschikt voor gebruik binnenshuis. Bescherm de beugel tegen regen,
vochtigheid en opspattende vloeistoffen. Zorg ervoor dat het draagoppervlak het gewicht van de
beugel en het toestel kan dragen.
• Houd vingers weg van scharnieren. Houd de beugel uit de buurt van kinderen en onbevoegden.
3. Algemene richtlijnen
Raadpleeg de Velleman® service- en kwaliteitsgarantie achteraan deze handleiding.
4. Eigenschappen
• voor lcd-schermen
• gemakkelijk te plaatsen
• conform VESA standaard 75/100 mm en 100/100 mm
• geleverd met alle nodige pluggen en schroeven voor montage en bevestiging
29/04/2011 ©Velleman nv
5
Loading...