Velleman VSCP1 User Manual

VISP1

PAN/TILT UNIT

USER MANUAL

1. INSTALLATION

The unit is intended to be mounted on a Wall Mount. Installation of the pan
and tilt drive to the wall mount requires a stainless steel 1/4-20 screw
supplied with the wall mount. Note the ribs on the underside of the unit base
engage slots in the mount. This allows positioning of the unit in any of four
directions with respect to the wall mount. Secure unit to the wall mount using
screw from underside of wall mount into unit and tighten.

2. WIRING OF UNIT

Fabricate the interconnecting cable in accordance with Figure 1. for proper
operation.

3. INVERTED MOUNTING

When the unit is mounted in the inverted position, the left-right directions are
reversed for manual operation. This must be corrected when wiring the cable
between control unit and the pan and tilt drive. Simply reverse leads going to
terminals 3 and 4.

4. ADJUSTING LIMIT STOPS

After cable is installed and unit has been mounted, proceed as follow :

1. Plug control unit into AC 24V source. Be sure auto switch is in the OFF
position.

POWER (red)
COMMON (black)
TILT DOWN (yellow)
TILT UP (blue)
PAN RIGHT (gr een )
PAN LEFT (white)

Figure 1

Cable Assembly Diagram

VSCP1-VISP1 VELLEMAN

1

2. To adjust pan limit stops (see Figure 2), loosen screws securing both
stops (1) and (3) to unit. Slide stops around unit to desired locations and
secure by tightening screws.

3. To adjust tilt limit stops (see Figure 2) located in each end plate, remove
two screws securing each end cap to unit. Loosen and adjust tilt limit
stop screws for desired tilt limit position. Tighten limit stop screws and
reinstall each end caps to unit and secure with two screws.

Figure 2

Limit Stop Adjustment and Camera Mounting Plate

VSCP1-VISP1 VELLEMAN

2