Velleman CS6MX-I User Manual
CS6MX
Operating Instructions
20
CS6MX
21
19
22
Identifying the Parts
1) On Off/ Sensitivity control
2) Iron Vol. control
3) Pinpoint switch
4) Disc Vol. control
5) Disc control
6) Ground control
7) Control box mounting clip
8) Loudspeaker
9) Battery compartment
10) 8 x AA battery holder
11) Battery contacts
12) Search-head socket
13) Headphone socket
14) Control box
15) Hand grip
16) Upper stem
17) Arm support
18) Detector rest
19) Stem lock
20) Lower stem
21) Interchangeable Search-head
22) Search-head xing screw and wing-nut
23) Search-head lead
23
9
14
7
15
17
16
18
10
9
14
12
11
7
6
3
2
8
1
2
4
5
CS6MX Overview
The CS6MX is a high performance specialist metal detector operating on the
‘MOTION’ principle. This means that the search-head must be kept moving at
a steady sweep speed to achieve optimum performance. The 6MX features
multiple discrimination allowing the user to detect the smallest and thinnest
coins on the most heavily contaminated or mineralised sites.
The CS6MX provides the option of interchangeable search-heads to
optimise performance on a variety of site conditions. There is an iron volume
control alongside a discrimination control with discrimination volume to aid
identication of targets; a pinpoint switch to aid exact target location; and a
manual / auto ground option to handle all ground conditions
CS6MX
The CS6MX is designed to offer extremely high performance and, with
practice, will give you excellent results. We wish you good hunting and
a great hobby with the excellent CS6MX!
3
Rapid start
Follow these simple steps to start using the CS6MX within minutes:
1) Insert the lower stem into the upper stem (rst press in the spring clip).
2) Twist the locking device so that the stem is locked at the required length.
3) Coil the search-head lead around the stem.
4) Plug the search-head lead into the socket on the control box.
5) Remove the battery compartment cover by loosening the four retaining screws.
6) Fit 8 x AA batteries to the battery holder being careful to observe polarity
and good contact and replace cover.
7) Rotate the Iron Volume control to number 8 on the scale.
8) Rotate the Disc control to number 4 on the scale.
9) Rotate the Disc Volume control to number 8 on the scale.
10) Set the Ground Control to ‘AUTO’.
11) Switch on and rotate the Sensitivity control to number 8 on the scale.
12) START DETECTING... Good metal targets give a sharp, high pitched audio
signal from the loudspeaker... Targets that have been discriminated will be
identied by a low tone tone... Signals from small pieces of iron are ignored...
Switch to pinpoint to identify the exact position of the target.
4
Loading...