Unitec Receipt Printer User Manual
WASHPAY
Receipt Printer Installa tion Instructions
The WashPay Receipt Printer should be centrally located and visible from all wash bays. Since the printer is
operator-accessible from the rear, the ideal location would be in the vicinity of the bill changer. The Receipt Printer
will be recess-mounted into a pre-cut hole using L-brackets.
Receipt Printer Specifications
Dimensions, Enclosure 7” W x 16” H x 12.1” D
Dimensions, Front Panel 10” W x 19” H
Weight 29 lbs
Enclosure Stainless Steel
Power 110-220VAC, 50-60Hz
Wiring CAT5E Cable
Important:
Follow the steps below to install the Recei pt Printer:
1. Disconnect all power routing to existing equipment.
2. Using the Receipt Printer dimensions shown in the following figure, determine where to mount the Receipt
Printer. Make sure the mounting location i s a solid surfac e.
3. Cut a hole for the Receipt Printer in the wall using t he dimensions in th e following figure.
4. Slide the Receipt Printer into the space you have created in the wall of the building. The back access door
will be inside of the building while the printer faces outside.
The WashPay Receipt Printer enclosures must be conn ected to earth ground.
Figure 1. WashPay Receipt Printer Dimensions
Document Number: WP1007
Document Title: WashPay Receipt Printer Installation Instructions
WASHPAY
5. Be sure that the flange on the front of the printer is flush with the wall.
6. Align the 1" side of the L-bracket with the holes on the side of Receipt Print er.
7. Insert 1 of the provided bolts into each hole and tighten snugly. Repeat this step to se cure the L-b ra c ket t o
the other side of the case.
8. Locate the three holes in the 1 1/2" side of the L-bracket that are facing the wall. Inset one of the drive
screws into each hole and tighten snugly. Repeat this step on the other side of the unit. The drive screws
will ensure that the flange on the front of the Receipt Printer fits snugly against the outer wall.
9. Plug the four-pin connector on the +24VDC external power supply to the four-pin jack located next to the
power switch on the distribution board, as sh own in the follo wing figure:
Figure 2. WashPay Receipt Printer Wiring
10. Pull a CAT5E cable from the patch panel in the office/equipment room to the Receipt Printer. The CAT5
cable should not exceed 300 feet in length.
11. Assemble the Tool-less RJ-45 connector onto the end of the CA T5 ca bl e (fol low th e in stru ctions i n cl uded in
the kit or from Appendix A of the WashPay Site Server Installation Manual). Make sure to use the “B” pinout configuration and that it matches the pin-out configuration of the other end of the CAT5 cable that is
plugged into the patch panel.
12. Plug the existing RJ-45 plug inside the printer enclosure into the Tool-less RJ-45 conn ector.
13. Plug the power supply into a 115VAC outlet.
14. Plug a CAT5 cable into the printer’s corresponding port on the patch panel and plug the other end of the
CAT5 cable into the LAST port on the router or Ethernet switch (the router assigns the paynodes in
sequential sequence so that all of the wash bays wil l be grouped toget her).
Please refer to the Documents and Downloads tab at
additional documents:
WashPay Site Server Installation Manual
WashPay Owners Manual
Sierra Management Application Programming Manual
Document Number: WP1007
Document Title: WashPay Receipt Printer Installation Instructions
www.StartwithUnitec.com for these
Loading...