Uniden UH037SX-2, UH037SX-4 User Manual

UH037SX-2 and UH037SX-4

UHF Radio Transceiver

OWNER’S MANUAL

CONTROL & INDICATORS

INCLUDED IN YOUR

INCLUDED IN

UH036SX PACKAGE

YOUR PACKAGE

dup

ch/

scan

vol/
mon

mic

1 Antenna
2 PTT (Push-To-Talk) Button
3 Channel/scan up Key
4 Channel/scan down Key

Duplex/Keylock Key

5 Duplex Key
6 Speaker
7 Power On/Off Key
8 Volume up/mon (monitor) Key

�

UH036SX x 2

UH037SX Radio

�

Operating Guide

Operating Guide

�

Belt Clips x 2

Belt Clips

*UH037SX-2 (x2), UH037SX-4 (x4)
Other printed materials may be included

RX TX

*

*

9 Volume down/mon (monitor) Key
10 Microphone
11 Battery Compartment Door
12 Channel Indicator
13 Receive Indicator
14 Battery Low Indicator
15 Transmit Indicator

1

OLD

NEW

GETTING STARTED

BATTERY WARNING

To retain the previous user settings, the UH036

The UH037SX will consume a small amount of battery

will continue to use a small amount of battery

power when switched off. To prevent the batteries from

power when switched off. To prevent the batteries from
running down, remove them from the radio if the

UH037SX

UH036SX will not be used for long periods.

running down, remove them from the radio if the
UH037SX will not be used for long periods.

BATTERY INSTALLATION

Your UH036SX radio uses 3 AAA ALKALINE batteries for power.

UH037SX

Use only good quality alkaline batteries for maximum life and
range. Note: Batteries are not supplied.

To avoid damage to the unit do
not mix old and new batteries.

1. Make sure your radio is off.

2. Remove the battery cover.

3. Insert 3 AAA ALKALINE batteries
according to the polarity symbols
inside the battery compartment.

UH037SX

4. Replace the battery cover.

2

WATER WARNING

Uniden does not represent
this product to be waterproof.
Do not expose this product to
Rain or Moisture.

BELT CLIP

To attach the belt clip:

Slide the belt clip until it snaps into
place.

To remove the belt clip:

To remove the belt clip. Pinch and
hold belt clip and latch (see arrows
indicated) and slide the belt clip in
the direction shown.

LOW BATTERY ALERT

If the Battery level becomes low, the
battery indicator icon will appear on
the LCD and begin flashing.

Pinch Belt Clip and Latch

The unit will go into a Battery Low Mode. The Transmit Mode
is disabled. Replace the batteries immediately to continue
using the radio.

3