Ubiquiti Networks NanoBridgM User Manual

Model:

NB-5G22

Introduction

Introduction

Thank you for purchasing the Ubiquiti NanoBridge™. This Quick
Start Guide is designed to guide you through the installation of
the NanoBridgeM5, model: NB‑5G22, and show you how to access
the airOS™ Configuration Interface.

Package Contents

Parabolic Reflector/Dish Antenna Feed Feed Support

Dish Bracket Pole Bracket Clamp M6 U‑Bolt

M6x12

Carriage Bolt

(Qty. 4)

24V PoE Adapter Power Cord

* Products may be different from pictures and are subject to change without notice.

M6 Bolt with

Lock Washer Assembly

(Qty. 4)

M6 Serrated

Flange Nut

(Qty. 6)

Feed Support

Bushing

1

NanoBridge™M5 Quick Start Guide

Application Examples

The NanoBridge mounted outdoors without the Dish Reflector
installed provides outdoor to indoor coverage using the 3 dBi feed
antenna only.

The NanoBridge mounted outdoors with the Dish Reflector
installed provides directional outdoor coverage (gain reflector
dependent).

Installation Requirements

• 10 mm wrench

• Shielded Category 5 (or above) cabling should be used for all

wired Ethernet connections and should be grounded through
the AC ground of the PoE.

We recommend that you protect your networks from the
most brutal environments and devastating ESD attacks
with industrial‑grade shielded Ethernet cable from Ubiquiti
Networks™. For more details, visit www.ubnt.com/toughcable

2

Installation

Installation

1. Install the Feed Support to the Dish Bracket using the four
M6Bolt with Lock Washer Assemblies.

2. Install the Dish Bracket to the Dish Reflector using the four
M6x12 Carriage Bolts and four M6 Serrated Flange Nuts.

3

NanoBridge™M5 Quick Start Guide

3. Route the Ethernet cable through the bottom hole of the Feed
Support and connect it to the Ethernet port on the back of the

Antenna Feed.

4. Insert the Antenna Feed into the Feed Support using the
orientation shown below.

4