Ubiquiti UALITE User Manual

UniFi Access Control Reader Lite

Model:

UA-Lite

System Components

Outside

UA-Lite

Note: Each UniFi Access component and all third-party

accessories are sold separately.

Installation Requirements

• Phillips screwdriver

• Ethernet cable, CAT5e or better

Sample Wiring Topology

PoE IN

UA-Hub

Motion
Sensor

Button

Door Position

Switch

Push

Push

Siren

External-Powered

Door Opener

Magnetic Lock

UVC-G3-FLEX

UA-Pro

UA-Lite

LEDs

UA-Lite

LED State Function

Flashing white Initializing
Steady blue Adopted / device is ready
Steady white Pending adoption
Flash blue twice NFC card detected
Flash white twice Access denied
Alternating white/blue Upgrading firmware

Hardware Installation

Note: Determine the installation locations for each

UA-Hub and door access reader. Cable runs for Ethernet
should not exceed 100 meters; wire runs for lock cables
should not exceed 45 meters.

Peripherals

To PoE BT

UA-Lite

UA-Pro

UVC-G3-FLEX

Sample UniFi Access Diagram

Access Reader

Run an Ethernet cable from the UA-Hub location to the install
location of the access reader. Depending on your system setup,
the access reader can be installed on either the inside or the
outside of the door.

UA-Lite

1. Place the UA-Lite mount against the wall and use it as a
template to mark the area where the UA-Lite will be installed.

2. Use the marked area as a guide to cut a hole in the wall for
the mount.

3. Pull the Ethernet cable from the wall and secure the mount to
the wall using two screws.

4. Connect the Ethernet cable to the back of the UA-Lite and
secure it to the mount.

5. Installation is complete.