Ubiquiti ETH-SP Installation Guide

Model: ETH-SP
Quick Start Guide
®
Hardware Overview
Eth In/Out
Grounding Point
ETH IN/OUT Passive, surge-protected
RJ45 Ethernet ports.
be grounded by one of the following methods:
• Using the included Self-Tapping Screw to ground the ETH-SP directly to a grounded metal pole or structure; or
• Using an M5 machine screw and nut (not included) to attach a drain wire that is connected to a remote grounding block or structure.
Package Contents
• ETH-SP
• M5 Self-Tapping Screw
• M5 Serrated Washer
Installation Requirements
Mounting accessories and optional drain wire are not included.
Pole-Mounting:
• Drill with a 4.5 mm drill bit
• (1) Metal strap or cable tie
Wall-Mounting:
(2) Screws (≤ 5 mm screw head)
• (1) M5 machine screw and nut
(1) Drain wire (≤ 16 AWG, ≤ 40 cm)
Connect a Drain Wire (Optional)
If a drain wire is used to properly ground the ETH-SP, attach it to the Grounding Point with an M5 machine screw and nut (not included).
Note: Place the included Serrated
Washer between the screw and drain wire.
Installation
Install the ETH-SP near an Ethernet device, either on a pole or a wall. Follow the appropriate steps for your installation:
Pole-Mounting
1. Thread a metal strap or cable tie (not
included) through the slot located on the back of the ETH-SP.
Note: If the Ethernet device is
mounted on the pole with a metal strap, you may use the same strap to attach the ETH-SP.
2. Wrap the strap or tie around the pole
and secure it to the pole.
3. Remove the port cover by pressing
on the center and sliding the cover downward.
Note: If you are using a drain wire
for grounding, proceed to the last section, Connecting Ethernet.
4. Drill a 4.5 mm pilot hole into the pole
through the center of the Grounding
Point of the ETH-SP.
4.5 mm Drill Bit
5. Insert the included Self-Tapping Screw
into the Serrated Washer and pilot hole. Securely fasten the screw to ensure the Grounding Point is bonded to the pole.
Loading...
+ 19 hidden pages