Trendnet TV-H400 Quick Installation Guide
Quick Installation Guide
TV-H400
V3.0R
Table of Contents
English 1
1. Before You Start
2. Hardware Installation 2
Troubleshooting 15
1
Version 01.08.2011
1. Before You Start
Package Contents
TV-H400
Ÿ
ENGLISH
System Requirements
The following items below are not included. Users must provide the items
themselves. Make sure to have each item on hand before installation.
Pan and tilt Internet camera (e.g. TV-IP410, TV-IP600, TV-IP612)
Ÿ
Ÿ Mounting screws and screw Anchors
ŸDry Wall or Wood surface
ŸPhillips screwdriver
ŸRJ-45 cable
ŸQuick Installation Guide
ŸPower Adapter (12V DC, 0.6A)
Ÿ4 x Enclosure Mounting Brackets
(BR001, BR002, BR003, BR004)
Ÿ
1 x Wall Mounting Bracket
Ÿ
1 x Ceiling Mounting Bracket
Ÿ Allen wrench (1/4”L=6mm)
Ÿ Screws and lock washers
(Bags: Q1, Q2a, Q2b, Q3, Q4, Q5, Q6)
Ÿ Rubber seal (Bag: Q7)
1
2. Hardware Installation
Note: Configure your Internet Camera Server to match your network before installing
the device.
TV-IP612P
Bracket: BR004
Bracket: BR001
:
Q7: Rubber Seal x 1
PCS
ENGLISH
Q6: Round Head
Screw x 3 pcs
Q3: 5cm Hex Screw
x 3 pcs
Q1: Flathead screw
x 3 pcs
Q5: Washer x 3 pcs
Hex Nut Top
x 3 pcs
2
TV-IP612P
1. Rotate the TV-H400's cover counter clockwise
ENGLISH
and remove the cover.
2. Remove three screws and remove the
protective plating from the TV-H400. Save these
screws. You will need to use these screws later.
3. Run all necessary cables (network cable,
Power Adapter cable, and the power terminals)
through the wall mount.
3
4. Connect the power terminal to the provided
12V DC, 0.6A power adapter. Adjust the cable
so that this connection is enclosed in the
bracket.
5. Run the Ethernet cable and the IP Camera's
power adapter cable through the opening
located at the top of the TV-H400.
6. After inserting the appropriate cables, extend
each cable to 6 inches for camera installation.
ENGLISH
7. Use the provided rubber seal to seal the
housing.
4
8. Secure the protective plating into the wall
mount bracket using the thumb screw.
ENGLISH
9. Screw the wall mount bracket on top of the
TV-H400 with the provided Allen wrench and
three hexagon socket screws. The screws are
in the plastic bag labeled Q2B.
10. Connect the three 5 cm Hex screws to the
circular base bracket. Secure the Hex screws
with the nuts and washers. The 5cm Hex
screws are in the plastic bag labeled Q3.
The nuts and washers are in the plastic bag
labeled Q5.
5
Loading...