Traxxas 6995 User Manual

Body Mounting
Instructions

Funny Car
Display Chassis

Covers Part #6995

1. (Skip to step 2 if you are installing a body you
have purchased separately). Dismount the body
from your vehicle by removing the screws that
secure the body pivot to the rear subframe.

2. Install the rear of the body on the display chassis
by inserting the supplied hardware through the
body pivots and chassis plates, then tighten
them in the plastic spacer bar.

All parts contained in this model, including the

wheels and tires, are for static display only.

DO NOT install on running vehicles.

Body Cutout
Instructions

The body will rest on the display chassis’ exhaust pipes when lowered.
To adjust the height of the body, carefully trim away the exhaust­clearance area as shown. Remove a small amount of material at a
time until the body is sitting properly over the chassis.

For best results, used curved scissors designed for trimming
lexan bodies. Or, trace the area using a hobby knife to score it,
then flex the lexan and peel out the waste material.
Use caution when handling a hobby knife.

If you have questions or need

technical assistance, call Traxxas at

1-888-TRAXXAS

(1-888-872-9927) (U.S. residents only)

Completed Installation

www.TRAXXAS.com

Traxxas, 1100 Klein Road, Plano, TX 75074,

6995-Funny_car-Chassis-Display-Cutout.indd 1 9/6/12 11:22 AM

Phone: [phone], Fax: [phone], e-mail: [e-mail]

KC1729 120823