Toshiba TCB-CA501BE, TCB-CA1401BE, TCB-CA801BE INSTALLATION MANUAL
Suction canvas
Refer to step(2)
Air conditioner
Fixing screw
Seal material
INSTALLATION PROCEDURE
Air conditioner
Refer to step (1)
Remove the screws on the back of
the air conditioner.
SUCTION CANVAS
Model: TCB-CA281BE, CA501BE, CA801BE, CA1401BE
INSTALLATION MANUAL
PARTS LIST
Parts name
TCB-CA281BE TCB-CA501BE TCB-CA801BE TCB-CA1401BE
Canvas fixing screw
4 4 10 10
(M4 x 30mm)
Turnbuckle 4444
Fixing screw
(M4 x 10mm)
4444
Suction canvas 1111
Before installing the suction canvas, check the following :
•
Check that heat insulation treatment is provided for the connection piping of the air conditioner.
•
Check the levelness of the air conditioner and gradient of the drain piping.
(1) Remove the screws on the back of the air conditioner.
The suction canvas is
to be installed here, so
you need to remove
these screws to install
it.
(2)Temporarily tighten 2 fixing screws to the air conditioner.
(The screw-in margin should be about 10mm.)
(3)Move the suction canvas to the direction of the arrow on
the left figure, and fix it by temporarily tightening 2
screws.
(4)After fitting the remaining screws, tighten all the screws
fully.
Installing the suction canvas
(It continues to the back.)
Model name
MMD-AP0071BH
to AP0181BH
RAV-SM561BT,SM562BT
MMD-AP0241BH
to AP0561BH
RAV-SM801BT
to SM1401BT
RAV-SM802BT
to SM1402BT
Number of the screw
2
5
Suction canvas
Seal material
CH58263501
Use the turnbuckle for adjustment.
(1) Install the attached turnbuckle to the suction canvas, and
hook the turnbuckle onto the chain so that there is no gap
between the mounting ceiling surface and ceiling panel.
(Before installing the turnbuckle, extend the screws so
that the groove faces upward.)
(2) Turn the turnbuckle clockwise until there is no gap
between the ceiling panel and ceiling surface.
Use the chain for adjustment.
Fix the chain with the chain fixing screws so that there is no
gap between the ceiling panel and ceiling surface.
Adjust the suction canvas
Turnbuckle
Indoor unit
more than
100mm
Slit
Ceiling panel
Adjustment height for canvas duct
Cut off the chain.
Chain fixing screw
Hanging hole of the turnbuckle
40 100mm
Adjustment height for canvas duct
Mount the ceiling panel. For details, refer to "Ceiling Panel Installation Manual".
•
Adjustment height of the suction canvas is more than 100mm:
•
Adjustment height of the suction canvas is
between 40mm and 100mm:
To prevent abnormal sounds, cut off the excessive portion
of the chain.
CAUTION
Loading...