Thermador VTI1010D-01 Installation Guide

Thermedor A, A,o_._c,o.gcon.

,4X IMPORTANT SAFETY INSTRUCTIONS

READ AND SAVE THESE INSTRUCTIONS.

This appliance conforms to the relevant safety
regulations.

Repairs should only be carried out by qualified
specialists.

Improperly executed repairs can give rise to significant
hazards for the user.

Z_ Your new appliance was protected on its way to

you by the packaging. None of the materials

cause

pollution to the environment and all can be recy-
cled for use again. Please help to protect the
environment and dispose of the packaging in an
environment-friendly manner.

You can obtain information about the best

method
disposing of old appliances and packaging from

your dealer or local municipal council.

/k

Check whether this fan may be combined with
the extractor hood.

/k

SAFETY WARNING: Before servicing or cleaning

unit, switch power off at the service panel and

lock service disconnecting means to prevent

power from being switched on accidentally.
When the service disconnecting means cannot

be locked, attach a tag to the service panel to

indicate power has been switched off for

maintenance.

/k

WARNING - TO REDUCE THE RISK OF FIRE,

ELECTRIC SHOCK, OR INJURY TO PER-
SONS, OBSERVE THE FOLLOWING:

A.

Installation work and electrical wiring must be
done by qualified person(s) in accordance with all
applicable codes and standards, including fire-

related construction.

B.

Sufficient air is needed for proper combustion
and exhausting of gases through the flue
(chimney) of fuel burning equipment to prevent
back drafting. Follow the heating equipment
manufacturers guideline and safety standards
such as those published by the National Fire
Protection Association (NFPA), and the American
Society for Heating, Refrigeration and Air
Conditioning Engineers (ASHRAE), and the local

code authorities.

C.

When cutting or drilling into wall or ceiling, do not

damage electrical wiring and other hidden utilities.

D.

To properly exhaust air, be sure to duct air out

side. Do not vent exhaust air into spaces within
walls, ceilings, attics, crawl spaces, or garages.

ik

WARNING: To reduce the risk of fire, use only

metal ductwork.

ik

CAUTION - For General Ventilating Use Only.
Do Not Use To Exhaust Hazardous Or Explosive
Materials And Vapours.

ik

This unit must be grounded.

ik

WARNING: To reduce the risk of fire or electric

shock, do not use this fan with any solid-state
speed control device.

Equipment Needed

[] Drill and Bit
[] Screwdriver

[] Rubber Mallet

Equipment Included

[] Anchors (4)
[] Screws (4)

[] Installation Instructions
[] Connector

PAGE 1