TagMaster AB
TagMaster AB
TagMaster S1566 Heavy Duty
HW Installation Guide
Manual issue 01
TagMaster AB
HW Installation Guide TABLE OF CONTENTS Manual issue 01
2
Disclaimer
The information in this document is subject to change without notice. While the information
contained herein is assumed to be accurate, TagMaster AB assumes no responsibility for any
errors or omissions.
Copyright
The copyright of this document is and will remain ours. No part of this document may be
reproduced or transmitted in any form or by means, electronic or mechanical, for any purpose,
without the express written permission of TagMaster AB.
FCC ID: M39S15XX
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired
operation.
NOTE: This equipment has been tested and
found to comply with the limits for a Class
A digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide
reasonable protection against harmful
interference when the equipment is operated
in a commercial environment. This equipment
generates, uses, and can radiate radio
frequency energy and, if not installed and
used in accordance with the instruction
manual, may cause harmful interference to
radio communications. Operation of this
equipment in a residential area is likely to
cause harmful interference in which case the
user will be required to correct the interference
at his own expense.
Caution
Information to user.
Changes or modifications not expressly
approved by the party responsible
for compliance could void the
user’s authority to operate the equipment.
Reg. No. 03-074
TagMaster AB
Electrum 410
S-164 40 KISTA
Sweden
Tel: +46-8-632 19 50, Fax: +46-8-750 53 62
Email: info@tagmaster.se Web: http://www.tagmaster.com
TagMaster AB
HW Installation Guide TABLE OF CONTENTS Manual issue 01
3
1 TABLE OF CONTENTS
1 TABLE OF CONTENTS...................................................................................................... 3
2 REVISIONS........................................................................................................................... 5
3 ASSOCIATED DOCUMENTATION ................................................................................. 5
4 INTRODUCTION................................................................................................................. 6
4.1 Audience.......................................................................................................................... 6
4.2 System Block Diagram.................................................................................................... 7
4.3 Definitions....................................................................................................................... 8
4.4 References .......................................................................................................................8
5 SAFETY NOTICE ................................................................................................................9
5.1 General ............................................................................................................................ 9
5.2 Specific warning and caution statements are used throughout this manual.................. 10
5.3 Installation..................................................................................................................... 10
6 SYSTEM COMPONENTS................................................................................................. 11
6.1 Communicators ............................................................................................................. 11
6.2 ID Tags.......................................................................................................................... 11
7 ENVIRONMENTAL CONSIDERATIONS ..................................................................... 12
7.1 General .......................................................................................................................... 12
7.2 Electromagnetic immunity ............................................................................................ 12
8 ELECTRICAL REQUIREMENTS................................................................................... 13
8.1 Temperature .................................................................................................................. 13
8.1.1 Communicators ..................................................................................................... 13
8.1.2 Tags ....................................................................................................................... 13
8.2 Supply Voltage.............................................................................................................. 13
8.3 Radio Interface ..............................................................................................................13
9 MECHANICAL INSTALLATION ................................................................................... 15
9.1 General .......................................................................................................................... 15
9.2 Readers .......................................................................................................................... 15
9.2.1 Mounting ............................................................................................................... 15
9.2.2 Connecting Cable recommendation ...................................................................... 16
9.3 ID-Tags.......................................................................................................................... 17
10 ELECTRICAL CONNECTIONS.................................................................................. 18
11 EARTHING REQUIREMENTS ................................................................................... 19
12 START-UP....................................................................................................................... 20
12.1 General .......................................................................................................................... 20
12.2 Inspection ...................................................................................................................... 20
12.3 Verifying communication ............................................................................................. 20
12.3.1 Serial host communication.................................................................................... 20
12.3.2 Reader - Tag communication ................................................................................ 20
13 TROUBLE SHOOTING................................................................................................. 22
13.1 An S1566 Reader malfunction ...................................................................................... 22
13.2 Unsuitable interface converters..................................................................................... 22
TagMaster AB
HW Installation Guide TABLE OF CONTENTS Manual issue 01
4
13.3 Interference.................................................................................................................... 22
13.4 Using wrong address ..................................................................................................... 22
13.5 Forgetting the free-wheel diode across inductive loads ................................................ 22
13.6 Using different data speed in the Tag(s) and in the Reader(s). ..................................... 22
13.7 Using an unsuitable power supply ................................................................................23
TagMaster AB
HW Installation Guide REVISIONS Manual issue 01
5
2 REVISIONS
Document revision history.
Revision Date Issued by Comment
01 2003-04-30 Dev. Dept. First issue
This document follows the TagMaster documentation version numbering standard to
identify the document version. This standard uses the form P01A, P01B to P01n for
draft versions (not for customer issue) then 01 for a released version (reviewed; can be
given to the customer). Subsequent issues use 02, 03, 04 etc and are changed via the
formal change control process.
3 ASSOCIATED DOCUMENTATION
51027803 TagMaster AB TagMaster HW Installation Guide
51021106 TagMaster AB Confident Programmer's Guide
TagMaster AB
HW Installation Guide INTRODUCTION Manual issue 01
6
4 INTRODUCTION
This manual describes the installation requirements and user information for the TagMaster
S1566 Heavy Duty Reader (HD-Reader).
4.1 Audience
The intended audience for this document is system integrators, installation engineers, contractors
or the like who have the task to install and commission the TagMaster systems. The audience is
expected to have adequate experience and education in the field of installation and
commissioning of control and identification systems and to be qualified for electrical
installations.
TagMaster AB
HW Installation Guide INTRODUCTION Manual issue 01
7
4.2 System Block Diagram
Microwaves
S1566 HD Reader
Interface cable
ID-Tag
Host
Diagram to show system and interconnections with a host and relation with tag.
Loading...