
2004
PRINTED IN JAPAN
0412 E
O307-39(U)-1E
CAUTION: Read this manual before operating.
Save this manual for future reference.

M037910E
Safety Caution
A-1
Safety Caution
Safety Caution
FCC NOTICE
This device complies with Part 15 of the FCC Rules.Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that
may cause undesired operation.
(1) Do not remove the certificate label.
The purpose of the certificate label on the
radio-control system is to certify that the
device conforms to the Radio Law. Using a
system without the certificate label is illegal.
Do not remove the certificate label.
(2) Dismantling/modification is
prohibited.
Do not dismantle or modify the radio-control
system. Dismantling or modifying the
radio-control system is illegal and
punishable.
Request a repair at the nearest TADANO
distributor or dealer if the radio-control
system has a problem.
Incorrect operation and inspection/maintenance of the crane is very dangerous,
causing bodily accidents such as death or serious injury. Before using the crane, carefull
read the operation and maintenance manual of the crane and this manual so that you full
understand them. Never operate and inspect/maintain the crane until you fully understand
the manuals.
M22318
Communication unitTransmitter
IC
:
*****
-RCSFR1
FCC ID
:
***
-RCS-FR1
…………………………
…………………………
…………………………
…………………………
…………………………
………………
IC
:
*****
-RCSFT1
FCC ID
:
***
-RCS-FT1
…………………………
…………………………
…………………………
…………………………
…………………………
………………
株
式
会
社
タ
ダ
ノ
製造番号
0
2
0
0
E
S
2
RCS‑FR1
I
C
:
*
*
*
*
*
‑RCSFR1
FC
C
ID
:
*
*
*
‑RCS‑FR1
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…

M037910E
Safety Caution
A-2
Safety Caution
(3) Always keep the transmitter clean.
When the transmitter gets dusty or dirty, wipe
the dust or dirt away with a dry soft cloth.
The attached dust or dirt may give
unfavorable impact on operations of the
motion selection switches or speed control
lever, causing operation failures or
malfunctions of the crane.
(4) Handle the transmitter with care.
Do not throw or drop the transmitter, as a
strong shock may cause damage or failure.
When you carry the transmitter with you, do
not drop it. Hang the transmitter onto a
portable hook or use an extended strap to
hang the transmitter from your neck.
(5) Store the transmitter in a safe place.
Store the radio-control transmitter in a safe
place after replacing it back into the
transmitter-storing bag. Do not leave or store
it in a place exposed to sunlight or rain or a
place with a high temperature or high
humidity.
M22310
M22321
M22319E
Portablehook
Strap
M22650E

M037910E
Safety Caution
A-3
Safety Caution
(6) Remove the batteries of the
radio-control transmitter when not in use
for a long time.
Remove the batteries of the transmitter when
the transmitter is not used for a long time, as
the batteries may leak if not removed.
(7) High pressure cleaning is prohibited.
Electric devices, such as control unit and
communication unit, may develop trouble if
water enters inside them. Please do not
clean the electric devices with high pressure.
(8) Pay attention to surrounding
conditions.
It is dangerous if your attention is paid only
to lifted cargos.
Also pay full attention to the conditions of the
main unit of the crane.
Especially, be careful with a vehicle turnover.
(9) Keep the lifted cargo weight lower
than the rated lifting capacity for empty
chassis.
Be careful with overloading to prevent
accidents.
M22313E
Dry battery
Battery cover
株
式
会
社
タ
ダ
ノ
製
造
番
号
0200ES2
R
C
S
-
F
R
1
IC
:
*
*
*
*
*
-R
C
S
F
R
1
F
C
C
ID
:
*
*
*
-
R
C
S
-F
R
1
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
…
M22655
M22651

M037910E
Safety Caution
A-4
Safety Caution
(10) Be careful with radio wave conditions.
Since the radio-control system uses radio
waves, it cannot avoid influences of
electromagnetic interference, radio interference
and exogenous noise. Such influences may
hinder the radio wave transmission, stopping
the crane operation.
Stopping of the crane during the operation may
cause dangers. It is especially dangerous
during a swing operation of the crane. Pay
attention to the following when operating the
radio-control system.
・ It is dangerous to operate the crane under
conditions with low radio wave
transmission, especially during a swing
operation of the crane since the crane
intermittently moves. Before starting the
operation, confirm that there is no problem
in the crane operation under no load
condition.
・ Too large a distance between the
transmitter and communication unit may
not only hinder the radio wave transmission
but also increase influences of noise.
Normally, operate within the operating
radius of the crane.
・ Obstacles such as wire nettings and metal
doors between the transmitter and
communication unit may hinder the radio
wave transmission.
・ Use manual control operation under
unfavorable radio transmission conditions.
・ Noise from a vehicle’s air-conditioner used
during the operation may cause an
intermittent crane operation. Refrain from
using an air-conditioner when its noise
influences the radio-control operation.
・ Noise from an approaching motorcycle to
the operation site may cause an
intermittent crane operation. Confirm that
there is no motorcycle approaching during
the operation.
M22652E
(Wire netting)
?
M22653
?