Supra SR153B50A User Manual

2

Here are the features of your new refrigerator.

Take a moment to know all the features and convenience it was designed to
provide. Numbers match those in the illustration on page 1.

§

Ice tray

Fill tray 3/4 full to allow expansion of water during freezing. Place tray in
freezer chest. To release cubes, twist lid slightly.

§

Shelf

Both shelves can be removed by pulling forward. The shelf can be placed
in either of two (higher or lower) positions.

§

Vegetable Crisper

May be used for vegetable storage. Both the crisper and its cover are
removable for easy cleaning. Simply slide forward to remove.

CAUTION: 1. Confirm your voltage before inserting the power supply cord

into the socket.

2. Contact the earthing conductor to this unit with an

attachment earthing screw.

3. DonÕt make it spill to this unit.

4. DonÕt work with flammable spray, such as painting, near this

unit.

5. DonÕt put ignitable materials, such as elther, benzine, LP,

Gas, alcohol, etc., into this unit.

6. Precaution to the leakage of any gas equipment near this

unit

7. Precaution not to hold on to the door of this unit by children.

8. Precaution not to reinsert the power supply cord within 5

minutes after release it from socket. If not, a trouble may be
occured to compressor.

1

NAMES OF P AR TS

! FREEZER SHELF
@ ICE BOX
# ICE TRAY
$ TEMP CONTROL DIAL
% LAMP SWITCH
^ SHELF
& CRISPER COVER B

* VEGETABLE

CRISPER

( FREEZER POCKET
) EGG POCKET
1 BOTTLE POCKET(S)
2 BOTTLE POCKET(L)
3 ADJUST FOOT

@
!

#

$
%

^

&
*

(

)

1

2

3

To change temperature

To start refrigerator

43

HOW TO INST ALL

HOW TO CLEAN

Cleaners: The cleaners noted below are available.Never use harsh, abrasive

cleaners, heavy-duty cleaners, or solvents on any surface.

Exterior: Wipe with damp, sudsy cloth, rinse and dry. For stubborn stains

and for periodic waxing, use silicon wax.

Freezer chest

: When refrigerator needs defrosting set TEMPERATURE

CONTROL at OFF. Do not use sharp instruments.

Refrigeration Section: Wash shelves drawers and other removable parts in

warm sudsy water, rinse and dry. Wash interior with
baking soda solution (3 Table spoons to one quart of
water) or warm sudsy water.

Magnetic Door Seals: Wash with warm sudsy water.
The Finishing Touch: Replace all parts and return TEMPERATURE

CONTROL to desired setting.

Location

Leveling

Install refrigerator in a convenient location away from extreme heat and cold.
Allow sufficient clearance between the refrigerator and side wall so the door will
open for a fully usable interior. Refrigerator is not designed for recessed
installation.

Level refrigerator so it rests solidly on the floor without rocking. There are two
leveling glides, one at each front corner. Turn to the left to raise a corner, to the
right to lower it. Use shims under rear corners, if necessary.

§ If you want, the refrigerator door to close when not held open, adjust glides

so that the front of the refrigerator is raised. However, front corners must
be level with each other, and rear corners with each other.

§ If you want, the refrigerator door to remain motionless when open, adjust

the leveling glides so that all four corners are level with each other.

NOTE : Make sure all packing material is removed. If the shipping tape has

left a residue on the door, touch the residue lightly with the
adhesive side of tape or with isopropyl alcohol (most rubbing
alcohol is this type).

Do not use a solvent, such as lighter or cleaning fluid, nor an
abrasive cleanser.

HOW TO OPERATE

1. TEMPERATURE CONTROL

Temperature is controlled automatically. The TEMPERATURE CONTROL at
the front side of the refrigerator section determines the amount of cooling
your appliance receives.

Many factors influence the internal temperature of the refrigerator section
and freezer section.

§ The temperature and humidity of the home.

§ The frequency of door openings and the amount of warm food placed in

the refrigerator.

§ The combination of foods and containers stored in the refrigerator

For these reasons, you may want to adjust the control to suit the season
and your needs. When adjusting the temperature:

§ Turn TEMPERATURE CONTROL toward PULL DOWN for colder

temperature in refrigerator and freezer sections, and toward MIN for
warmer temperature in both sections.

§ Allow approximately 12 hours or overnight for temperature to stabilize.

Then check to see if further adjustments are necessary.

Set

TEMPERATURE CONTROL at MED.

To turn off refrigerator

Disconnect the power supply cord. Remove ice tray and food. Leave
doors ajar for air circutation and dehumidification of both sections.