Dynamic Series |
Subwoofer |
SDS-8, SDS-10, and SDS-12 |
SDS-8230, SDS-10230, and SDS-12230 |
Quick Start Guide |
Important Safety Instructions
1.Read these instructions.
2.Keep these instructions.
3.Heed all warnings.
4.Follow all instructions.
5.Do not use this apparatus near water.
6.Clean only with dry cloth.
7.Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
8.Do not install near any heat sources such as radiators, heat registers, stoves or other apparatus (including amplifiers) that produce heat.
9.Do not defeat the safety purpose of the polarized or grounding type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. If the provided plug does not fi t into your outlet, consult an electrician for replacement of the obsolete outlet.
10.Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.
11.Only use attachments/accessories specifi ed by the manufacturer.
12. Use only with the cart stand tripod bracket or table speci-
fi ed by the manufacturer or sold with the apparatus. When a cart is used use caution when moving the cart/apparatus combination to avoid injury from tip-over.
13.Unplug this apparatus during Iightning storms or when unused for long periods of time.
14.Refer all servicing to qualifi ed service personnel. Servicing is required when the apparatus has been damaged in any way such
as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.
15.This apparatus has been equipped with a rocker-style AC mains power switch. This switch is located on the rear panel and should remain readily accessible to the user.
16.The mains plug or an appliance coupler is used as the disconnect device, so the disconnect device shall remain readily operable.
WARNING
To reduce the risk of fi re or electric shock, do not expose this apparatus to rain or moisture.
To fi nd out more about this and other Sunfire products, please visit our website: www.sunfire.com
Introduction
Thank you for purchasing a Sunfire Dynamic Series Subwoofer. We hope you enjoy it and the music it makes as much as we have enjoyed creating it for you.
The big features of the subwoofer are its high-efficiency Class D digital amplifier, and its computer-optimized woofer and passive radiator design. And, the Sunfire Dynamic
Series' extended frequency response means that your subwoofer is the perfect match to virtually any loudspeaker. The result is extraordinarily high operating efficiency – that is, more acoustic output for each watt of input.
Unpacking
Your Sunfire subwoofer should reach you in perfect condition. If you do notice any shipping damage, please contact your Sunfire Dealer immediately.
Gently lift out the unit and remove all the packing material. It is important to save all the packing materials and the box in case your subwoofer ever needs to be moved or shipped for repair.
Make sure that you keep your sales receipt. It is the only way to establish the duration of your Limited Warranty and it may come in useful for insurance purposes.
Please take a moment to read the serial number located on the control panel and record it here:
Serial Number:
Purchased from:
Date:
Features
•Low distortion
•Premium quality driver and passive radiator
•Extremely compact size
•Automatic signal-sensing turn-on and standby mode
•Line-level inputs
•Line-level high-pass outputs
•Phase control
•Crossover frequency control
•Volume control
•Soft clipping circuit allows graceful overload and prevents speaker damage due to clipping
Care
To maintain the speaker cabinet’s finish, fi rst unplug the power cord and then use a soft cloth to clean the surfaces.
If your Sunfire subwoofer needs servicing, please read the troubleshooting section in the user manual. The user manual can be downloaded from www.sunfire.com
Service
If your Sunfire product ever requires service, please write to us or call:
Sunfire,
1300 E New Circle Road, Suite 150 Lexington, KY 40505
Phone 859-514-8290
Fax: 859-269-7972
Warranty
Sunfire, a division of Elan Home Systems, LLC, is proud of its products which have been built with care using advanced technology and premium component parts. Your unit has been crafted to perform properly for many years. The warranty details for your product are shown on the sunfire website.
Specifications
Amplifier Output
SDS-8/SDS-8230 200W RMS, 400W Peak
SDS-10/SDS-10230 250W RMS, 500W Peak
SDS-12/SDS-12230 300W RMS, 600W Peak
High Cut Filter
50 Hz - 150 Hz adjustable. The crossover can
be bypassed by rotating the crossover frequency
control fully clockwise.
Frequency Response
SDS-8/SDS-8230 |
32 Hz - 150 Hz |
SDS-10/SDS-10230 |
30 Hz - 150 Hz |
SDS-12/SDS-12230 |
28 Hz - 150 Hz |
Power Line Voltage
115 VAC 50/60 Hz version
230 VAC 50/60 Hz version
Dimensions
(with grill and feet) |
|
SDS-8/SDS-8230 |
13.62 x 11.73 x 12.48 in |
|
346 x 298 x 317 mm |
SDS-10/SDS-10230 |
15.12 x 13.23 x 13.97 in |
|
384 x 336 x 355 mm |
SDS-12/SDS-12230 |
16.65 x 14.57 x 15.52 in |
Weight |
423 x 370 x 394 |
|
|
SDS-8/SDS-8230 |
20 lb (12.7 kg) |
SDS-10/SDS-10230 |
27 lb (15.4 kg) |
SDS-12/SDS-12230 |
35 lb (17.2 kg) |
Finish |
|
Black Ash. |
|
Output levels: |
|
Peak SPL (including room gain):
SDS-8/SDS-8230 100 dB
SDS-10/SDS-10230 103 dB
SDS-12/SDS-12230 106 dB
Drivers:
SDS-8/SDS-8230 |
8 in (203.2 mm) |
SDS-10/SDS-10230 |
10 in (254 mm) |
SDS-12/SDS-12230 |
12 in (304.8 mm) |
Location
Your SDS Subwoofer is designed to be placed in a corner for optimum performance.
Experiment with at least two corners and decide which sounds the best.
Although low frequencies are non-directional, room refl ections, standing waves, resonance and absorption strongly affect the performance. Moving the subwoofer from one corner to another can have a major effect on the bass response.
Keep it at least two or three feet away from any CRT screen, computer, VCR or magnetic tapes and discs. This will reduce the chance of the magnetic fi elds upsetting the CRT screen or erasing your magnetic media.
Also position the control panel so that it is not touching anything and can receive good ventilation.
Using Two Subwoofers
With two subwoofers, the sound output will double. Place each subwoofer in a corner, and experiment with the location and phase control to achieve the best bass response.
© 2010 Sunfire, a division of Elan Home Systems, LLC. All rights reserved. Sunfire reserves the right to improve its products at any time. Therefore, specifications are subject to change without notice.
Quick Start Guide 913-164-00 Rev A