Sunbeam 4181 User Manual

Model
4181
6 Speed
Blender
USER MANUAL
IMPORTANT SAFEGUARDS
READ ALL INSTRUCTIONS BEFORE USE.
When using electrical appliances, basic safety precautions should always be followed, including the following:
Read all instructions. Keep these instructions for future use.Verify that the voltage in your home corresponds to that of your
appliance.
To protect against risk of electrical shock, do not put cord, plug, base,
or motor in water or other liquid.
Close supervision is necessary when any appliance is used by or near
children.
Unplug cord from outlet when not in use, before putting on or taking
off parts and before cleaning.
Avoid contact with moving parts. Do not operate any electrical appliance with a damaged cord or plug
or after the appliance malfunctions or has been dropped or damaged in any manner. Return appliance to nearest Sunbeam Appliance Authorized Service Center for examination, electrical repair, mechani­cal repair, or adjustment.
The use of attachments, including canning jars, not recommended by
the manufacturer may cause a risk of injury to persons.
Do not use outdoors.Do not let cord hang over the edge of a table or counter or touch hot
surfaces, including the stove.
Keep hands and utensils out of container while blending to reduce
the risk of severe personal injury and/or damage to blender. A rubber spatula may be used but must be used only when blender is not running.
Do not use a broken, chipped or cracked blender jar.Do not use broken, cracked or loose cutting blades.To reduce the risk of injury, never place cutting blades unit on base
without jar properly attached. Blades are sharp. Handle carefully.
Always operate blender with cover in place.When blending hot liquids, remove center piece of two-piece cover.
Do not fill blender container beyond 3-cup level. Always begin pro­cessing at the lowest speed setting. Keep hands and other exposed skin away from the cover opening to prevent possible burns.
Screw on blade assembly firmly. Injury can result if moving blades
become exposed.
If the jar should turn when the motor is switched ON, switch OFF
immediately and tighten blade assembly.
Do not leave blender unattended while it is operating.To disconnect cord, turn the control to OFF, then remove the plug
from wall outlet.
Do not use appliance for other than intended purpose.
THIS UNIT IS FOR HOUSEHOLD USE ONLY.
This appliance intended for household use only. Use for food or
liquids only.
This appliance is equipped with a polarized plug. This type of plug
has one blade is wider than the other. This plug will fit in a polarized outlet only one way. This is a safety feature intended to help reduce the risk of electrical shock. If you are unable to insert the plug into the outlet, reverse the plug. If it the plug should still fail to fit, contact a qualified electrician to replace the obsolete outlet. Do not attempt to defeat this safety purpose of the polarized plug by modifying the plug in any way.
The length of the cord used on this appliance was selected to reduce
the hazards of becoming tangled in, or tripping over a long cord. If a longer cord is necessary an approved extension cord may be used. The electrical rating of the extension cord must be equal to or greater than the electrical rating of the blender. Care must be taken to arrange the extension cord so that it will not drape over the countertop or tabletop where it can be pulled on by children or accidentally tripped over.
If the blender blades lock and do not move, it will damage the motor.
Do not use. Call the toll-free customer service number for information.
Do not place blender in the freezer filled with food or liquid. This will
freeze and damage the blade assembly, jar and motor.
SAVE THESE INSTRUCTIONS
1
2
Important Safeguards Inside Cover Welcome 2 Learning About Your Blender 3 Using Your Blender 4 Hints For Best Use 6 Cleaning 7 Servicing 7 One-Year Limited Warranty 8 How To Obtain Warranty Service 9
Table of Contents
Welcome
Congratulations on your purchase of Sunbeam®Model 4181 Blender. Your product includes the following features: A total of 6 Speeds including a pulse function for continuous and controlled cycle operation.
3
KNOW YOUR BLENDER
A. Filler-Cap B. Lid C. Jar (48 ounce) D. Gaskets (small gasket for blade assembly, large gasket for jar collar) E. Blade Assembly (also called cutting blades) F. Base G.Control Panel H. Pulse Button- For instant control the pulse operates only as long as
the button is held down. The blender motor stops when the button is released.
A
B
C
D
F
G
H
E
4
HOW TO USE YOUR SUNBEAM® BLENDER
After unpacking the blender, wash everything except the blender base in hot, soapy water. Dry thoroughly. Do not place in dishwasher. Wipe the blender base with a damp cloth or sponge. Do not immerse the base in water. Care should be taken when handling the blades, as they are very sharp.
How to Assemble and Use Important: Your blender jar and cutting blades are subject to
wear during normal use. Always inspect cutting blades for broken, cracked or loose blades. If jar or cutting blades are damaged, do not use. Call our toll-free customer service number to obtain replacement parts.
Make sure blender is unplugged. Place blender base on
clean, dry surface to keep foreign particles from being pulled up into motor during operation.
Make sure small gasket is in place on outer rim of blade
assembly. The gasket must lie flat. Screw the blade assem­bly into the jar base firmly. The large gasket should be in place on jar bottom, underneath the wide collar.
The blade assembly must be screwed into the jar firmly.
If not, it may loosen when the motor is turned on.
Set jar into place on blender base, making sure it is
securely seated. If not gently rock the jar until seated.
Plug cord into outlet.Put ingredients in jar, place lid on jar.Process food or beverages. Place hand on lid when blend-
ing liquids. Push button on control panel to start blender.
Always turn blender OFF and wait until blades have
stopped rotating before removing jar.
To remove jar after blending is complete, lift the jar
straight up. If it is not easily removed, gently rock and lift. Do not twist.
Never place jar onto unit while motor is running.
5
6-Speed
Speeds are Chop, Mix, Grate, Blend, Liquefy, and Pulse/Off. Pulse is a controlled cycle operation. This means it operates only while the button is held down. All other speeds are continuous cycle operation. They operate continuously at whatever speed is selected until the “Off” button is pressed.
For Continuous Operation
Rest one hand on top of the blender jar with lid securely in place. Press desired speed button to turn blender on. Press “Off” button to turn blender off.
For Controlled Cycle Operation
Rest one hand on top of blender jar with lid securely in place. Press “Pulse” button and hold down for about 2 seconds. Release button and allow blades to coast to a stop. Repeat cycles until contents reach a desired consistency. Release of the “Pulse” button turns blender off.
NOTE: “Pulse” button can be held longer than 2 seconds as needed.
6
HINTS FOR BEST USE
Processing hot foods or liquids in the blender may cause
hot liquid to spurt out when the cover is removed. Always remove the filler-cap from the cover before blend­ing hot foods or liquids. (Please review Important Safeguards).
To add foods when blender is operating remove filler-cap
from container cover and add ingredients through the opening.
If using your blender to make salsa or other recipes using
tomatoes, onions and/or other vegetables, you may have better results using a slower speed function.
If blending action stops during blending or ingredients
stick to the sides of the jar, turn blender OFF. Remove the cover and use a rubber spatula to push mixture towards blades.
Do not try to mash potatoes, mix stiff dough, whip egg
whites, grind corn or raw meat, or extract juices from fruits and vegetables. The blender is not made to perform these tasks.
Do not store food or liquids in the blender jar.Avoid bumping or dropping the blender.
Loading...
+ 16 hidden pages