
Controls
3205
TIME VOICE MIX
FILTER MODREPEATS
hold (tap)
3005
multi
dBucket delay
1. TIME
Controls the delay time
according to the selected VOICE.
2. VOICE
Selects the BBD chip style and
configuration. This aects the
tonal character and time range:
3205 (30–300ms) recreates a
low voltage MN3205 chip circuit
for gritty repeats—great for slapback, leads, and sci-fi sounds
3005 (100ms–1 sec) recreates
a higher voltage, dual MN3005
BBD chip circuit for longer delay
times with a dreamy quality
multi creates complex
soundscapes with two crosscoupled, super-clean BBD delay
lines with golden ratio timing

Controls - continued
3. MIX
Controls the delay mix from full
dry at minimum to full wet at
maximum. A 50/50 mix occurs
at approximately 3 o’clock on
the knob.
4. FILTER
Adjusts the filtering, noise, and
bucket loss of the repeats based
on the selected VOICE.
5. REPEATS
Varies number of delay repeats
from one to runaway oscillation.
6. MOD
Adds LFO modulation to the
delay time
.
7. FOOTSWITCH
Engages and disengages the
eect. Red LED indicates the
eect is engaged.
Hold to enter/exit Tap Mode and
tap quarter notes to set the
delay time. TIME knob sets the
TAP DIVISION when in Tap
TAP DIVISION options are:
and
The LED will flash to indicate the
tempo. Maximum tap range is 2
seconds.
Mode.
Support
Download the Full User Manual
strymon.net/support/brig
Questions & Technical Support
support@strymon.net

Rear Panel
IN OUT EXP/MIDI 9VDC
USB
stereo
stereo
mono
mono
1. I/O MODE SELECTOR
mono
mono input, mono output
mono stereo
mono input, stereo output
stereo
stereo input, stereo output
Stereo I/O requires a TRS adapter or
cable. See User Manual for details.
2. USB
Computer connection for MIDI I/O
and firmware updates.
3. INPUT
High impedance TRS, ultra low-noise
discrete Class A JFET stereo preamp
4. OUTPUT
Low impedance TRS stereo output.
5. EXP/MIDI
Can be set to operate in one of five
modes: Expression Pedal, Favorite,
Tap, Infinite, or MIDI.
See
User Manual
for details.
6. 9VDC
Only use an adapter with the
following rating: 9VDC, centernegative, 250mA minimum (sold
separately).
.