Structural Concepts CSF3931 Installation Manual

READ AND SAVE THESE INSTRUCTIONS

INSTALLATION &

OPERATING MANUAL

SELF-SERVICE FLOOR MODEL UNITS

PN 99696

Models: CSF3931 39”L x 73 1/4”H* x 31”D
CSF4231 42”L x 73 1/4”H* x 31”D**

* Includes Top Sign
** Without Package Ledge. 36 1/2”D With Package Ledge.

888 E. Porter Road · Muskegon, MI 49441 Phone: [phone] Fax: [phone] www.structuralconcepts

I:\Oper Manuals\Addenda\CSF[L]31_99696.pub

Model Shown With

Optional Upper Signage

Rev B Date: 8.27.2007

TABLE OF CONTENTS

OVERVIEW AND WARNINGS ……………………..…………………..…….………….....…..………

INSTALLATION ………….…………………………………………………………………………………
START-UP AND OPERATION ……….. …..….…………………...………...…..………………………

MAINTENANCE FUNDAMENTALS ………………………….………………………………... .. …... .

SERIAL LABEL & LOCATION / INFORMATION LISTED / ADD’L TECH INFO & SERVICE ..……
TROUBLESHOOTING ……………….……………………………………………….………….… ……..
ILLUSTRATED PARTS BREAKDOWN …………………………………………………….…...………
PARTS LIST ……………..………………………………………………………………………… ………
CLEANING SCHEDULE..…………………………………………………...…………… …….…… … …
WARRANTY…………...……………………………………………………..……………………..………

TECHNICAL SERVICE……..…………………………………………………………… ….….....………

3
4
5
6
8

9
10
11
12
13
14

2

OVERVIEW AND WARNINGS

OVERVIEW

• This merchandiser is designed for the display of non-hazardous, unpackaged bakery

products.

• These cases should be installed and operated according to the following instructions to

insure proper performance.

• This unit is designed for the display of products in ambient store conditions where

temperatures and humidity are maintained at a maximum of 75° F and 55% relative
humidity.

WARNING

ELECTRICAL
HAZARD

CAUTION

WARNING

Risk of Electric Shock.

Disconnect Power Before Servicing Unit

CAUTION

Lamps have been treated to resist breakage and must be replaced with a

similarly treated lamp.

3

INSTALLATION

Remove Unit From Skid

• Position the unit near a suitable electrical outlet.

• Caution: case must always remain supported or

center of gravity imbalance will cause case to fall.

• Slide unit to rear of skid and tip backward off skid.

Position and Level Units

For your safety, equipment is furnished with a
properly grounded cord connector. Do not at­tempt to defeat the grounded connector.

Lift unit with suitable prying bar and blocking. Note
the point of lifting to minimize damage to case. Ro­tate leveler to obtain proper height to stabilize and
level the unit.

Level Units with

7/16 Wrench

4

START-UP AND OPERATION

For your safety, equipment is fur­nished with a properly grounded
cord connector. Do not attempt to
defeat the grounded connector.

Merchandiser Start-Up

• Do not use an extension cord with

this appliance.

• Do not operate this equipment with

a damaged cord, plug or outlet.

• Insure the power switch is off.

• Plug cord into a certified 120V elec-

trical outlet with ground.

• Turn lights on.

• On floor models without a stor-

age door the switch is located at
the front base of the unit under
the front panel on the left hand
side.

• On floor models with a storage

door, the switch is located inside
the base storage area on the left
hand side.

• Lights should come on at the same

time. First time lighting may require
a short warm up period for the
bulbs. Slightly dim or a flickering of
new bulbs is normal.

Tissue Dispenser

• Remove tissue dispenser.

• Place a tissue box into the dis-

penser as shown.

Internal

Light Switch

Storage Door

When Provided

Tissue Dispensers vary

depending upon model

Light Switch

5