Strong SRT 5505 MHP User Manual

Safety First

Removing the decoder’s cover may lead
to a severe & potentially fatal electric

shock.

This digital decoder has been manufactured to meet
international safety standards. However, safety precautions
must be followed to ensure the safe and reliable operation
of the decoder.

Please take note of the following guidelines to avoid the

risk of an electric shock.

This decoder operates with an external power supply

in the range of 100 to 240V AC, 50/60 Hz. Use a
standard AC wall outlet; a DC power source cannot
be used. Remember that contact with 110-240 Volts
AC power supply can be lethal.

Ensure that all electrical connections are properly

made before connecting the decoder to the power
supply. Always unplug the decoder before connecting
or disconnecting any cables.

Whenever you connect the decoder to the power

supply, always connect the power lead to the power
input connector on the back panel of the decoder
before you connect the power brick to the wall socket
outlet.

Whenever you disconnect the decoder from the

power supply, always remove the power brick
from the wall socket-outlet before you remove
the other end of the lead from the power input
connector on the back panel of the decoder.

Never attempt to repair or reconstruct the

decoder yourself. A serious electric shock may
occur if this decoder is repaired, disassembled
or reconstructed by an unauthorized person.

Be extremely careful if this unit is in contact with

water. Immediately disconnect the power brick
if possible.

DO

9 If anything falls into the cabinet, unplug the

decoder and have it checked by a qualified
technician.

9 Allow adequate air circulation to prevent internal

heat build-up. Do not place the unit next to a
radiator or any heat source and make sure that
the air vents are not covered.

DO NOT

× … expose the decoder to extreme temperatures,

direct sunlight or high humidity.

× … place any objects on top of the decoder in

order to allow air circulation.

× … place the decoder on fabric furnishings,

carpets or other flammable materials.

Unpacking Your Digital Decoder

As you unpack your digital decoder, please make sure that the following accessories are included:

Decoder Remote

Control

Power brick SCART

cable

Telephone

modem cable

RF coaxial cable Batteries

Maintenance

If you wish to clean your box, disconnect it first of all from the power supply. To clean the box, use a soft, dry cloth.
For very dirty surfaces, dip a soft cloth in a weak soap-and-water solution and wring well. After cleaning, wipe with a
soft, dry cloth. Never use alcohol, paint thinner, or a chemically treated cloth to clean this unit. Such chemicals may
damage the unit’s finishing.

7

SRT 5505 mhp

Software upgrade

Please be aware your decoder’s software may be automatically updated from time to time. This upgrade can only
be done when the decoder is in the standby mode. You will then be informed by a screen prompt that the new
software version has been found and that the upgrade will begin. If you wish to perform this upgrade manually you
may do so by going to Menu / Installation / Decoder status / Upgrade decoder / Ok.

Connectivity Diagram

Front Panel

Indicator light:
Green - operating mode

in standby, low power consumption

Red -

The indicator light flickers when your
decoder is receiving signals from the
remote control

Smart Card allows you to view
scrambled TV and Radio channels.
Gently push the card into the slot.
Its chip should face downwards and
the symbol of an arrow should face
inwards..

SRT 5505 mhp

8