7. Place circuit board in the new case bottom. Be sure the white
connector is aligned over the holes in the case bottom. 8. Set the circuit board in place.
9. Set the bind button onto the blue button.
10. Put four screws in case bottom and screw case back together. WARNING: Be sure the antenna wire is not
crimped between the cases. Do not over-tighten the screws or the case could be damaged.
11. Press the bind button to be sure it operates freely.
WARNING: A range check must be performed before flying the module to ensure it is functioning properly.
Install the module in your transmitter and perform an advanced range check following the instructions in the
Spektrum™ Air Module System Manual.
If you have questions about these procedures, please contact the Spektrum Service Center nearest to you for assistance.
For US customers, please contact: For our European Union customers, please contact one of the following locations:
Horizon Hobby, Inc.
4105 Fieldstone Road
Champaign, IL 61822
Please call toll-free, 877-504-0233
or email us at webmaster@horizonhobby.com
©2010 Horizon Hobby, Inc. Spektrum radios and accessories are distributed exclusively by Horizon Hobby, Inc. 4105 Fieldstone Road, Champaign, IL 61822
The Spektrum trademark is used with permission of Bachmann Industries, Inc. spektrumrc.com
Printed 12/09 17677
white
connector
holes in
case
bottom
Horizon Hobby UK
Units 1-4 Ployters Rd
Staple Tye, Harlow
Essex CM18 7NS
United Kingdom
Please call +44 (0) 1279 641 097
or email us at sales@horizonhobby.co.uk.
Horizon Technisher Service
Hamburger Str. 10
25335 Elmshorn
Germany
Please call +49 4121 46199 66
or email us at service@horizonhobby.de