Sony Ericsson DSC-F707 User Manual

Camera

Guide

Westborough, MA 01581

Sony DSC-F707/Sony DSC-F717

Recommended Camera Settings for OneShot 360™

After Attaching the OneShot360 unit, and powering the camera on:

• Zoom: Use the Zoom to exactly fill the digital camera LCD viewer screen
with the circular image. Use the zoom (T) rocker button on the left side of
the camera lens. If you zoom in too much, you will lose part of the field of
view. If you zoom in too little, you will not get maximum resolution. Note
also that the OneShot image may not be exactly centered in the LCD
screen – this is normal.

• Flash: Make sure the flash is disabled. Press the flash arrow on the
control button (lightning bolt symbol) located above the LCD screen on the
back of the camera. Press the button until you see the “flash off” icon on
the LCD.

REMOTEREALITY

4 Technology Drive

866-898-1010

• Focus: To focus your OneShot image with the Sony DSC-F707/DSC-
F717, slide the Focus switch on the left side of the camera lens to Manual.
Turn the focus ring on the camera lens until the desired distance is shown
on the LCD panel. We recommend a setting of 3 meters (or 9 3/4 ft.)

• Aperture Priority Mode: Put your Sony DSC-F707 in aperture priority
mode by turning the top mode dial to A, the symbol for aperture priority.

• Aperture: Adjust the Jog Dial (in front of the shutter button) left/right to
select the f-stop (it will turn yellow in the LCD display). Press down on the
jog dial, release, and then turn it left/right to adjust to an f-stop of f-8.

• Self-timer: Select the self-timer by pressing the “down” arrow above the
self-timer symbol on the Control button. You will need to select self-timer
for each image that you take.

NOTE: You can use shutter priority mode, as long as you use a shutter speed
that gives you the desired f# of 8. Also, make sure you are using a tripod when
shooting with a slow shutter speed.

Press the MENU button and use arrow buttons to:

• Image Size: Under the Image Size menu, set the image size to
2560x1920 for best quality.

• Image Quality: Under the P.Qual menu, set the picture quality to Fine.

• ISO Sensitivity: Under the ISO menu, set the sensitivity to 100.

• Sharpness: In the Sharpness menu, set the sharpness of the image to 0.

Doc. 000820, Rev. A Sony DSC-F707/Sony DSC-F717 www.remotereality.com

Page 1 of 2

Camera

Guide

Recommended Camera Settings for 360Plus

When taking 360x360 images, follow all of the above instructions, and the
additional instructions below.

Because the 360Plus uses 4 images, it is best to make sure that all 4
images have the same exposure. This will ensure the end result will have
a continuous tone and density throughout the image. The best way to do
this is to:

• Look at the aperture and shutter speed settings shown in the LCD
screen. If the numbers change while shooting the 4 360 images
needed for a 360x360, then the exposure is changing between
shots. Try to make the scene as evenly balanced with the same
type of light as possible. For example, close window shades and
turn on interior lights.

REMOTEREALITY

4 Technology Drive

Westborough, MA 01581

866-898-1010

• You can also push the AE lock button located on the left side of the
lens. This will keep the exposure setting from changing between
shots, but you must push the AE lock button after each shot so the
exposure will lock for all four shots.

• Use the bubble level to set the lens mount to a level position before
taking the first shot.

• Do NOT re-level between shots. It is normal for the bubble level to
shift between shots. Re-leveling is not necessary and not
recommended.

• When proces sing 360Plus images in the RemoteReality software,
choose Parashot in the Optical Attachment drop-down menu. The
camera setting should be Sony DSC-S70 in the camera selection
menu.

Doc. 000820, Rev. A Sony DSC-F707/Sony DSC-F717 www.remotereality.com

Page 2 of 2