Sony XM-GTR2202 BROCHURE

XM-GTR2202

2/1 channel GTR amp

220 Watts x 2 RMS (20Hz-20kHz, <1%THD+N, at 4 Ohm, 14.4V)

Maximum power output of 440 Watts per channel at 4 Ohm.

270 Watts x 2 RMS (20Hz-20kHz, <1%THD+N, at 2 Ohm, 14.4V)

Maximum power output of 650 Watts per channel at 2 Ohm.

540 Watts x 1 RMS (20Hz-20kHz, <1%THD+N, at 4 Ohm mono, 14.4V)

This unit can be used as a bridging amplifier with a maximum output of 1400 Watts at 4 Ohms.

Direct connection (High Level Input) can be made with the speaker output of your car audio unit if it is not equipped with RCA line output.

Hi-

Level Sensing power On feature allows the unit to be activated

without need for remote connection.

Built in variable 12 dB/Oct LPF (Low Pass Filter) from 50-300Hz enables users to concentrate the power on lower frequencies.

Built in variable 12 dB/Oct Subsonic filter from 6-70Hz enables users to create a band pass filter and block extremely low frequencies to improve the subwoofer systems efficiency.

Variable 0-10 dB 40Hz bass boost provides additional bass response at lower frequencies.

Sony Electronics Inc. • 16530 Via Esprillo • San Diego, CA 92127 • 1.800.222.7669 • www.sony.com

Last Updated: 04/13/2011

XM-GTR2202

2/1 channel GTR amp

Please visit the Dealer Source for current information at

www.sony.com/dealersource

Features

220 Watts x 2 RMS at 4 Ohms

440 Watts x 2 max power at 4 Ohms

270 Watts x 2 RMS at 2 Ohms

650 Watts x 2 max power at 2 Ohms

540 Watts x 1 RMS at 4 Ohms

1400 Watts x 1 max power at 4 Ohms This unit can be used

as a bridging amplifier with a maximum output of 1400 Watts at 4 Ohms.

High Level input with Sensing Power On Direct connection (High Level Input) can be made with the speaker output of your car audio unit if it is not equipped with RCA line output. Hi

Level Sensing power On feature allows the unit to be activated without need for remote connection.

50-300 Hz Variable Low-pass filter, 12 dB/oct Built in variable 12 dB/Oct LPF (Low Pass Filter) from 50-300Hz enables users to concentrate the power on lower frequencies.

6-70 Hz Variable subsonic filter, 12 dB/oct Built in variable 12 dB/Oct Subsonic filter from 6-70Hz enables users to create a band pass filter and block extremely low frequencies to improve the subwoofer systems efficiency.

0-10 dB Variable 40Hz Low boost Variable 0-10 dB 40Hz bass boost provides additional bass response at lower frequencies.

Specifications

Audio

Frequency Response: 10 - 50 kHz (+0/-3 dB) Input Level: 0.3 - 6.0V (RCA input) or 1.2 - 12.0V (High Level Input) Impedance: 2-8 Ohms Stereo or 4-8 Ohms Mono Operation: 2/1 channel configuration Tone Control(s): Low Pass Filter: 50-300Hz, 12dB/Oct

Subsonic filter: 6-70Hz, 12dB/Oct

Harmonic Distortion: 0.05% (at 1kHz) Low Boost: 0-10dB Variable (at 40Hz) Signal-to-Noise Ratio (dB): 93 dBA

Power

Output Power: Maximum Output: 440 Watts x2 or 1400 Watts x1

(at 4 Ohms)

Current Drain: At rated output: 50A (at 4 Ohms)

Remote Input: 1 mA

Rated Output: (20Hz-20kHz, 1% THD+N, 14.4V) 220 Watts x 2

RMS (4 Ohms) 270 Watts x 2 RMS (2 Ohms) 540 Watts x 1 RMS Mono (4 Ohms)

Power Requirements: 12V DC Car Battery (Negative Ground) Internal Power Supply: OTL Output Transformerless Circuit

Pulse Power Supply

Input Voltage: 10.5-16V Power Supply Voltage

Inputs and Outputs

RCA Audio Input(s): Pin Jacks: 0.3 - 6V Audio In: RCA Pin Jacks, High Level Input Connector Audio Out: Speaker terminals with screws

Dimensions

Weight: 7 lbs. 15 oz. Measurements: 16 3/4 x 2 1/4 x 11 1/8" (424 x 55 x 280 mm)

Supplied Accessories

Mounting Screws (4) High Level Input Cord (1) Protection cap (1)

Color:

Gray and Silver

UPC Code:

027242773066

1. CEA-2006 Compliant —

Standardized “Voluntary”

Testing & Measurement Methods for Mobile Audio

Amplifiers. This standard advocates a uniform method for determining an amplifier’s RMS power and signal

to-noise ratio. Using 14.4 volts, RMS watts are measured into a 4-ohm impedance load at 1 percent Total Harmonic Distortion (THD) plus noise, at a frequency range (for general purpose amplifiers) of 20 Hz to 20,000 Hz.

d, ZAPPIN, and the Sony and Xplōd logos are trademarks of Sony. iPod is a trademark of Apple Inc. All other trademarks are trademarks of their respective owners. Features and specifications are subject to change without notice. Non-metric weights and measures are approximate and may vary.