XM-3001SXD/6001GXD
SERVICE MANUAL
Ver 1.1 2003. 08
Photo: XM-6001GXD
SPECIFICATIONS
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL HARMONIC DISTORTION
300 watts minimum continuous average power into 4 ohms, 20 Hz to
300 Hz with no more than 0.1% total harmonic distortion per Car
Audio Ad Hoc Committee standards.
US Model
Other Specifications
Circuit system PWM (pulse width modulation) circuit
Inputs RCA pin jacks
Outputs Speaker terminals
Speaker impedance 1 – 8 Ω
Maximum outputs 600 W (at 4 Ω)
Rated outputs (supply voltage at 14.4 V)
Frequency response 5 Hz – 300 Hz ( dB)
Harmonic distortion 0.06% or less (at 100 Hz, 4 Ω)
Pulse power supply
High level input connector
Through out pin jacks
1200 W (at 2 Ω)
300 W (20 Hz – 300 Hz, 0.1% THD, at 4 Ω)
600 W (20 Hz – 300 Hz, 0.4% THD, at 2 Ω)
1000 W (20 Hz – 300 Hz, 0.8% THD, at 1 Ω)
+0.5
–3
Input level adjustment range
0.2 – 6.0 V (RCA pin jacks)
0.4 – 12.0 V (High level input)
Low-pass filter 50 – 300 Hz, -18 dB/oct
Low boost 0 – 10 dB (40 Hz)
Phase shift adjustment range (XM-6001GXD)
0° – 180° (at 40 Hz)
Power supply voltage 10.5 – 16 V
Current drain at rated output : 40 A (4 Ω)
Remote input : 2 mA
Dimensions Approx. 358 × 50 × 264 mm
(w/h/d) (14 1/8 × 2 × 10 1/2 in.) not incl.
projecting parts and controls
Mass Approx. 3.5 kg (7 lb. 11 oz.) not incl. accessories
Supplied accessories Mounting screws (4)
Design and specifications are subject to change without
notice.
Notes on Chip Component Replacement
• Never reuse a disconnected chip component.
• Notice that the minus side of a tantalum capacitor may be
damaged by heat.
9-873-513-12
2003H04-1
© 2003. 08
MONAURAL POWER AMPLIFIER
Sony Corporation
e Vehicle Company
Published by Sony Engineering Corporation
1
XM-3001SXD/6001GXD
TABLE OF CONTENTS
1. GENERAL
XM-3001SXD:
Features ................................................................................ 3
Location and Function of Controls.......................................3
Installation ............................................................................ 3
Connections .......................................................................... 4
XM-6001GXD:
Features ................................................................................ 6
Location and Function of Controls.......................................6
Installation ............................................................................ 6
Connect.................................................................................7
2. DISASSEMBLY
2-1. Plate, Bottom.......................................................................9
2-2. Main Board Section ............................................................ 9
2-3. Main Board ......................................................................... 9
2-4. LED Board .......................................................................... 9
3. DIAGRAMS
3-1. Block Diagram .................................................................. 10
3-2. Printed Wiring Board –Main Section– .............................. 12
3-3. Schematic Diagram –Main Section (1/2)– ........................ 14
3-4. Schematic Diagram –Main Section (2/2)– ........................ 15
4. EXPLODED VIEWS
4-1. Heat Sink (Main) Section..................................................17
4-2. Main Board Section .......................................................... 18
5. ELECTRICAL PARTS LIST ........................................ 19
2
XM-3001SXD:
SECTION 1
GENERAL
XM-3001SXD/6001GXD
This section is extracted
from instruction manual.
3