Sony XA-300 Service manual

XA-300

SERVICE MANUAL

Ver 1.1 2002.08

SPECIFICATIONS

Power requirement 12 V DC car battery

Current drain 340 mA Operating temperature –10°C to +55°C

Dimensions Approx. 148 × 34 × 101 mm

Mass Approx. 470 g (1 lb 16 oz.) Supplied accessories BUS cable

(negative earth)

(14° F to 131° F)

/8 × 1 3/8 × 4 in.)

(5 (w/h/d)

RCA pin cord Velcro tape

US Model

Canadian Model

AEP Model

UK Model

E Model

FEATURES

The XA-300 is an external selector for connecting a Sony BUS system-compatible CD/MD device or a non-compatible portable device (such as a DVD player, MD Walkman, or laptop computer) to a Sony BUS system-compatible master unit. Enjoy the sound of portable media in your car.

WALKMAN is trademark of Sony Corporation.

Design and specifications are subject to change without notice.

AUX-IN SELECTOR

9-873-500-12 Sony Corporation

2002H0500-1 e Vehicle Company C 2002.08 Published by Sony Engineering Corporation

XA-300

1. SERVICING NOTES ................................................ 2

2. GENERAL ................................................................... 3

3. DIAGRAMS

3-1. Note for Printed Wiring Board and

Schematic Diagram ......................................................... 3

3-2. Printed Wiring Board ...................................................... 4

3-3. Schematic Diagram ......................................................... 5

3-4. IC Pin Function Description ........................................... 6

4. EXPLODED VIEW................................................... 7

5. ELECTRICAL PARTS LIST ............................... 8

SECTION 1

SERVICING NOTES

Connection to repair

This set is controled by master unit with serial communication.

SET

BUS CONTROL OUTPUT terminal

Therefore, to operate this set, connect master unit as shown below.

Connecting via USB

This set can be connected via its USB connector to a parsonal computer with USB port.

• Compatible operating systems – Windows

Windows (Windows

– Mac OS 8.6 or later

(Mac OS 9.0 or later recommended)

98 Second Edition/

Me/Windows® 2000

2000 recommended)

MASTER UNIT

BUS CONTRO INPUT terminal

Notes on chip component replacement

• Never reuse a disconnected chip component.

• Notice that the minus side of a tantalum capacitor may be damaged by heat.

∗1

∗3

VOL

MIN

MAX

∗4

MIN MAX

Place the unit under the passenger seat, etc. (

Before installation

•Choose the installation location carefully so that the unit does not interfere with normal driving operations.

•Avoid installing the unit where it would be subject to: —high temperatures, such as from direct

—draft, rain or moisture. — dust or dirt. —magnetic fields.

•Use only the supplied mounting hardware for a safe and secure installation.

If you have any questions or problems concerning your unit that are not covered in this manual, please consult your nearest Sony dealer.

Stick one piece of the Velcro tape provided to the bottom of the unit and the other to the surface of the car where you want to place it (such as the carpet underneath the passenger seat) in order to hold the unit in position. After removing the dust and dirt from the surface of Velcro tapes, stick them together.

)

sunlight or hot air from the heater.

Connection example (3)

∗1 You can connect the source selector (XA-

C30, etc.) compatible with the Sony BUS system. For details, refer to the user's manual for the source selector you are using.

∗2 Supplied with the CD/MD changer ∗3 Vo lume control for headphones connected

to AUX IN 1.

∗4 Stereo mini-plug ∗5 USB connector

• Computer with USB port

• Compatible operating systems –Windows

–Mac OS 8.6 or later

Note

Depending on the device to be connected, you might need to buy a different connector cord. For further details, read the operating manual of the device to be connected or ask your local dealer.

98 Second Edition/

Me/Windows® 2000

Windows

(Windows

2000 recommended)

(Mac OS 9.0 or later recommended)

OUTPUT

AUX IN 1

SECTION 2

GENERAL

Equipment used in illustrations (not supplied)/Equipements utilisés dans les illustrations (non fournis)/Apparecchiature utilizzate nelle illustrazioni (non in dotazione)/In den Abbildungen gezeigte Komponenten (nicht mitgeliefert)/Geïllustreerde apparatuur (niet meegeleverd)/Equipmento utilizado nas ilustrações (não fornecido)/Εξοπλισµς που χρησιµοποιείται στις εικνες (δεν παρέχεται)/Utrustning som används i illustrationerna (medföljer inte)/Equipo utilizado en las ilustraciones (no suministrado)

Master unit Appareil principal Unità principale Hauptgerät Master unit Unidade principal

Κύρια συσκευή

Huvudenhet Unidad principal

AUDIOAUDIO

CONTROLCONTROL

INPUT

USB

AUX IN 2

AUDIO

AUDIOHEADPHONE

LVOL R L R

To select a device connected to the unit by the master unit

1Press (SOURCE) repeatedly until “CD” is

selected.

2Press (MODE) repeatedly until the device

you want to listen to is selected. Example: Master unit display window

B CD1 B CD2/AUX1

CD4/USB b

Tip

When you select a Sony BUS systemcompatible device, it will automatically start playing.

3 Start playing the device selected in 2.

For the playback method of the selected device, refer to its operating manual.

4 Adjust the volume of the master unit and

selected device.

Notes

• Follow the steps below to play the audio file of the computer connected to the USB jack of this unit. 1 Press the MODE button of the master

unit to select “USB.”

2 Open the playback software (Windows

Media Player, etc.) on your computer. 3 Play the audio file (MP3,etc.). After playing the audio file on the computer, if you select “USB“ mode on the display of the master unit, this unit may not recognize the signal and sound may not come out.

• As the volume settings of each connected device may differ, adjust the volume on each device separately. As the sound output differs on AUX IN 1 and AUX IN 2, connect the Sony car audio DVD changer to AUX IN 1, and connect a portable device (such as MD WALKMAN, etc.) to AUX IN 2.

• While playing audio file in a device connected to AUX IN 1, AUX IN 2, or the USB jack on this unit, do not change any settings of the CD CUSTOM FILE function. If trouble occurs, press the SOURCE button again on the master unit to select the device you want.

∗2

∗5

MD Walkman, etc. Walkman MD, etc. MD Walkman, e così via. MD-Walkman usw. MD Walkman, enz. Walkman de MD, etc.

MD Walkman, κλπ.

MD Walkman eller liknande Walkman de MD, etc.

CD3/AUX2 b

CD/MD changer Changeur CD/MD Cambia CD/MD CD/MD-Wechsler CD/MD-wisselaar Carregador de CD/MD

CD/MD changer

CD/MD-växlare Cambiador de CD/MD

This section is extracted from instruction manual.

Laptop computer Ordinateur portable Computer portatile Laptop-Computer Laptop computer Computador laptop

Φορητς υπολογιστής

Bärbar dator Ordenador portátil

DVD player, etc. Lecteur DVD, etc. Lettore DVD, e così via. DVD-Player usw. DVD-speler, enz. Leitor de DVD, etc.

DVD player, κλπ.

DVD-spelare eller liknande Reproductor de DVD, etc.

Headphones Casque Cuffie Kopfhörer Hoofdtelefoon Auscultadores

Ακουστικά

Hörlurar Auriculares

SECTION 3

DIAGRAMS

3-1. NOTE FOR PRINTED WIRING BOARD AND SCHEMATIC DIAGRAM

Note on Printed Wiring Board:

• X : parts extracted from the component side.

•

: internal component.

• : Pattern from the side which enables seeing. (The other layers' patterns are not indicated.)

Caution: Pattern face side: Parts on the pattern face side seen from (Conductor Side) the pattern face are indicated. Parts face side: Parts on the parts face side seen from (Component Side) the parts face are indicated.

•Waveforms

1 IC1 es (XTAL)

3.9 Vp-p

99.5 ns

Note on Schematic Diagram:

• All capacitors are in µF unless otherwise noted. pF: µµF 50 WV or less are not indicated except for electrolytics and tantalums.

• All resistors are in Ω and 1/ specified.

•

: internal component.

• C : panel designation.

• A : B+ Line.

• H : adjustment for repair.

•Power voltage is dc 14.4V and fed with regulated dc pow er supply to master unit.

•Voltages and waveforms are dc with respect to ground under the condition that master unit is connected. no mark : CD - C (): AUX 1 []: AUX 2 〈〈 〉〉 : USB

•Voltages are taken with a V OM (Input impedance 10 MΩ). Voltage variations may be noted due to normal production tolerances.

•Waveforms are taken with a oscilloscope. Voltage variations may be noted due to normal production tolerances.

• Circled numbers refer to waveforms.

• Signal path.

F : AUDIO E : USB IN j : USB OUT

2 IC3 wk (XTO)

83 ns

XA-300

W or less unless otherwise

3.6 Vp-p

XA-300

Ver 1.1

3-2. PRINTED WIRING BOARD

MAIN BOARD

(COMPONENT SIDE)

FB501

1-682-009-

(CONDUCTOR SIDE)

C105

ZD104

Q301

(11)

MAIN BOARD

C101

R101

ZD102

R202

ZD103

R201 D104

Q203

Q202

R203

R204

Q201

R302

R301

C303

R303

ZD301

C302

C301

C505

C506

R501

C502

X102

R514

C501

R503

C503

R502

C504

CN101

INPUT

CONTROL

ZD402

321

654

R404

R405

ZD405

Q101

C103

C102

Q303

Q302

ZD403

ZD404

Q102

C106

C104

R102

IC8

ZD101

R103

C507

C510

C516

C511

C509

IC3

R505

R504

ZD401

R402

R403

C108

Q104

Q103

C109

R143

C110

X101

C514

R512

IC4

R511

R510

R506

C512

R508

R509

R507

CN104

INPUT AUDIO

R401

ZD602

Q402

C115

D103

IC2

IC1

C111

R614

R513

C518

R613

C517

C513

C608

R606

R607

R608

C603

ZD604

ZD601

C107

C112

Q801

Q802

C114

C515

C113

C601

C611

R603

IC5

R612

R611

0 1 6 C

C609

C602

R609

2 0 6 R

C607

R601

R605

ZD603

Q803

D101

RY101

C605

R604

R610

C606

C604

R706

R708

C705

ZD702

RY102

R720

R722 R721

C722

R719

C720

C719

C718

R702

R707

C702

R705

CN108

OUTPUT

AUDIO

ZD901

ZD902

R904

Q804

IC6

C717

R701

ZD701

R903

Q902Q901

D102

L902

RY103

C703

R703

C701

C706

R709

(AEP, UK)

R710

ZD703

C704

R704

C707

R717 R715

C713

C730

R407

R406

Q903Q904

L901

C708

C715

CN102

OUTPUT

CONTROL

ZD406

321

ZD407

R408

R410

ZD410

C716

R718

C714

R716

654

ZD409

R409

R714

C709

ZD408

IC7

C710

R711

RV101

VOL

C712

C711

R713

C721

R712

1-682-009-

(11)

• Semiconductor Location

Ref. No. Location

D101 E-18 D102 E-20 D103 D-15 D104 D-13

IC1 F-15 IC2 D-16 IC3 H-13 IC4 G-14 IC5 H-17 IC6 G-19 IC7 H-22 IC8 D-15

Q101 D-13

Ref. No. Location Ref. No. Location Ref. No. Location

Q102 D-14 Q103 D-13 Q104 D-15 Q201 E-13 Q202 D-13 Q203 D-13 Q301 F-13 Q302 F-13 Q303 F-13 Q402 C-16 Q801 E-17 Q802 E-17 Q803 D-17 Q804 E-19 Q901 D-19

Q902 D-20 Q903 D-21 Q904 D-21

ZD101 E-14 ZD102 D-13 ZD103 D-13 ZD104 D-13 ZD301 F-13 ZD401 B-14 ZD402 B-14 ZD403 C-14 ZD404 C-14 ZD405 C-14 ZD406 B-22

ZD407 B-22 ZD408 C-22 ZD409 C-22 ZD410 C-22 ZD601 B-17 ZD602 C-16 ZD603 I-17 ZD604 I-16 ZD701 I-19 ZD702 I-18 ZD703 I-20 ZD901 C-20 ZD902 C-19

CN103

USB

CN106

AUX IN 2

AUDIO

CN105

AUX IN 1

AUDIO

CN107

HEADPHONE

+ 8 hidden pages

Sony XA-300 Service manual

TABLE OF CONTENTS

SERVICING NOTES

GENERAL

DIAGRAMS

3-1. NOTE FOR PRINTED WIRING BOARD AND SCHEMATIC DIAGRAM

3-2. PRINTED WIRING BOARD