Wireless Speaker System
Quick start guide
SRS-BT100iK
Features
• Wireless speaker and transmitter for streaming of highquality stereo music from iPod.
• Transmits music to speaker using Bluetooth® wireless
technology.
• Speaker and transmitter have been pre-paired for easy
connection and use.
• Bluetooth Version 2.0 + EDR (Enhanced Data Rate) for
higher quality audio with less interference.
• Transmitter power supplied from iPod so no additional
battery or charging is needed (for transmitter only).
• Powerful sound with 30W amplifiers and MegaBass (for
speaker only).
• Includes one analogue input for direct connection from
music players and other audio devices (for speaker only).
• Magnetically-shielded design for use near your TV or
monitor (for speaker only).
• You can enjoy listening to music wirelessly by using the
transmitter and the speaker separately to be used together
with other Bluetooth devices*
*1The connected Bluetooth device is required to support A2DP
(Advanced Audio Distribution Profile).
iPod with dock
connector port (30 pin)
1
.
Compatible iPod models
The compatible iPod models are as follows.
Update your iPod to use the latest software before you use
it.
This transmitter
This speaker
On copyrights
• iPod is a trademark of Apple Inc., registered in the U.S.
and other countries.
• The Bluetooth® word mark and logos are registered
trademarks owned by Bluetooth SIG, Inc. and any use of
such marks by Sony Corporation is under license. Other
trademarks and trade names are those of their respective
owners.
Notes
• This transmitter is designed for iPod only. You cannot connect
any other portable audio players.
• Sony cannot accept responsibility in the event that data recorded
to iPod is lost or damaged when using an iPod connected to this
unit.
• This transmitter has been designed specifically to work with iPod
and has been certified to meet Apple performance standards.
4-115-481-01(1)©2008 Sony Corporation Printed in Malaysia
Getting started
Hooking up the speaker
Connect the supplied AC power adaptor to the speaker.
(rear)
To wall outlet
To DC IN 12 V
jack
AC power adaptor (supplied)
Hooking up the transmitter
Connect the transmitter to the dock connector port of an
iPod firmly.
2 Press the power button of the transmitter
for about 1 second to turn it on, or start
playback on the iPod.
The indicator of the transmitter flashes twice
(Playback will start automatically).
When the Bluetooth connection is made
properly, both the power indicator (green) and
communication status indicator (blue) of the
speaker light up indicating that pairing is
completed.
Notes
• If the Bluetooth connection is not established within about 5
minutes. The transmitter automatically turns itself off. In
this case, start over from step 2.
• If playback cannot start automatically, try to start playback
on the iPod.
• If the source device has a bass boost function or equalizer
function, set them to off. If these functions are on, sound
may be distorted.
3 Adjust the volume.
Press the VOLUME + or - button on the speaker.
Note
A beep sounds when the volume is set to minimum or
maximum.
Dock connector
port (30 pin)
Power button
Listening to sound
1 Press the 1 (power) button of the
speaker to turn it on.
The power indicator (green) of the speaker lights
up.
1 (power) button
To finish listening
Terminate the Bluetooth connection by any of the
operations below.
• To turn off the transmitter, press and hold the transmitter’s power button for about 1 second. The indicator of
the transmitter flashes once and the power turns off.
• To turn off the speaker, press and hold the speaker’s 1
(power) button for about 1 second. The power indicator
of the speaker goes off.
• Turn off the iPod.