Sony PCS-G70, Revolabs Fusion PCS-G50 Setup Manual

Revolabs FusionTM Microphone System — Sony PCS-G70 Setup Guide

This setup guide will guide you through the steps needed to properly connect a
Revolabs Fusion Microphone System to a Sony PCS-G70 video codec.

Note:

It is important to carefully follow these instructions in order and completely.
Otherwise your Fusion Microphone System and/or the video codec may not function
properly. Please read through these instructions completely before proceeding.
Contact Revolabs technical support if you have any questions.

Requirements for connecting systems:

1. Revolabs Fusion 4 or 8 channel Microphone System

2. Sony PCS-G70 video codec

3. QTY 1 Female XLR—1/8” mono male cable* (i.e. Calrad 10-144)

4. QTY 1 RCA male — RCA male cable

5. Amplified Speakers

* Optional Item

Connecting the Cables

1. Connect a Female XLR – 1/8” audio cable between the XLR “CONF OUT” port on
the Fusion and the “MIC 1” port on the PCS-G70.

2. Connect a Male RCA-RCA audio cable between the “CONF IN” port on the
Fusion and the non-mixed “AUDIO OUT” port on the PCS-G70.

3. Connect a Male RCA audio cable between the “Room Out” port on the Fusion
and the Amplified Speakers.

3

1

1

2

2

NOTE: You must use your Fusion remote control to control the room volume
for both the audio and video conference calls. Adjusting the volume in the
video codec will cause echo.