Sony IRF302U Installation guide

Installation Description

IRF302U shall be installed in various kinds of Sony products.

When IRF302U is installed in a product, we shall consider the following points;

1. Since IRF302U owns its FCC ID number, we shall affix an exterior label on the outside of the
product if the FCC ID is not visible. The exterior label shall use wording such as either
“Contains Transmitter Module FCC ID: AK8IRF302U” or “Contains FCC ID: AK8IRF302U “.

2. IRF302U complies with requirements of sub-sections 15.203, 15.205, 15.207, 15.247 and

15.407 in FCC Rules Part 15. We shall install IRF302U in accordance with their requirements.
IRF302U complies with requirements of the sub-section 2.1091. When installers install
IRF302U into a product, they shall ensure that the public is not exposed to radio frequency
energy levels in excess of the Commission’s guidelines in accordance with the sub-section

15.247(b)(5) and 15.407(f) in FCC Rules Part 15.

3. Special Accessory (Shielded tape and Ferrite Core) must be patched for RF inference.
Please refer to the following picture.

4. This equipment complies with FCC radiation exposure limits set forth for at uncontrolled
equipment. This equipment should be installed and operated with minimum distance at least
20cm between the radiator and persons body (excluding extremities: hands, wrist, feet and
legs) and must not be co-located or operated with any other antenna or transmitter.

Shielded tape

Ferrite Core

Details of Ferrite Core
Model: SFC-3
Manufacture: Kitagawa Industries Co., Ltd.

Shielded tape

Ferrite Core