Sony CECHYA-0075 Instruction Manual
Wireless Headset
Bluetooth® Headset
User’s Guide
BEFORE USING THIS PRODUCT, CAREFULLY READ THE SUPPLIED DOCUMENTATION.
CECHYA-0075
WARNINGS
• To reduce the risk of electric shock, explosion or re, use only the
supplied charging cradle or the supplied USB cable to charge the
product. Do not use the charging cradle with other products or for
any other purpose.
• Charge the headset according to the supplied instructions.
NOTICE
This device complies with Part 15 of the FCC Rules and RSS-Gen of
IC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
FCC WARNING
Change or modications not expressly approved by the party responsible for compliance could void the user’s authority to operate
the equipment.
Declaration of conformity
Trade name: Sony Computer Entertainment America
Model number: CECHYA-0075
Responsible party: Sony Computer Entertainment America Inc.
Address: 919 E. Hillsdale Blvd., Foster City, CA 94404 U.S.A.
Telephone number: 650-655-8000
For customers in Canada
This Class B digital apparatus complies with Canadian ICES-003.
Caution
Do not handle damaged or leaking Lithium-ion batteries.
Lithium-ion batteries
The headset is equipped with a non-replaceable battery. Do not
attempt to open the headset or remove the battery. Lithium-Ion
batteries are recyclable. Check local laws for disposal instructions.
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This transmitter must not be co-located or operated in conjunction
with any other antenna or transmitter.
This equipment complies with FCC/IC radiation exposure limits
set forth for uncontrolled equipment and meets the FCC radio
frequency (RF) Exposure Guidelines in Supplement C to DET65 and
RSS-102 of the IC radio frequency (RF) Exposure rules. This equipment has very low levels of RF energy that are deemed to comply
without testing of specic absorption ratio (SAR).
CONTENTS
WARNINGS 2
Before use 4
Precautions 4
Getting assistance 4
Part names 5
Charging your headset 5
Charging Time 5
Using the charging cradle 5
Charging without the cradle 6
Pairing your headset 6
Pairing with the PS3™ system:
automatic mode 6
Pairing with the PS3™ system:
Bluetooth
Pairing with a mobile phone 7
Turning your headset on and o 8
To turn on your headset 8
To turn o your headset 8
Connecting your headset to Bluetooth
Testing and configuring the headset 8
Wearing your headset 9
Adjusting the fit 9
Changing the ear clip 9
Headset features for your PS3™ system 9
User action indicator 9
Notifications 10
HQ mode 10
Desktop Mic mode 11
Using your headset with a mobile phone 11
Headset controls 11
When connected to a PS3™ system 11
When connected to a mobile phone 12
Headset indicators 12
General indicator lights 12
Indicator lights when connected
to a mobile phone 12
Headset tones 13
Troubleshooting 14
Product specifications 15
Limited warranty 15
®
discovery mode 7
®
devices 8
BEFORE USE
4
This guide contains instructions for setting up and using your Bluetooth®
headset (wireless headset) with your PS3™ system as well as with
other Bluetooth®-compatible mobile phones and audio devices.
Precautions
Before using this product, carefully read this manual and retain it for
future reference. Additional warnings may be present on the product,
packaging, or in the user instructions.
Safety
• Observe all warnings, precautions and instructions.
• CHOKING HAZARD - Small parts. Not for children under 6 years.
Use and handling
• Permanent hearing loss may occur if the headset is used at high
volume. Set the volume to a safe level. Over time, increasingly
loud audio may start to sound normal but can actually be damaging
your hearing. If you experience ringing in your ears or mufed
speech, stop listening and have your hearing checked. The louder
the volume, the sooner your hearing could be affected. To protect
your hearing:
– Limit the amount of time you use the headset at high volume.
– Avoid raising the volume to block out noisy surroundings.
– Lower the volume if you can’t hear people speaking near you.
• Do not use the headset if it causes discomfort to your skin. If the
headset causes discomfort to your skin, discontinue use immediately. If symptoms do not subside even after discontinuing use,
seek medical attention.
• Do not expose the headset or accessories to high temperatures,
high humidity or direct sunlight.
• Do not put heavy objects on the headset or accessories.
• Do not allow liquid or small particles to get into the headset or
accessories.
• Do not throw or drop the headset or accessories or subject them
to strong physical shock.
• Do not place any rubber or vinyl materials on the product exterior
for an extended period of time.
• Make sure the headset is kept clean and free of ear wax buildup
to maintain the specied product performance.
• Use a soft, dry cloth to clean the headset or accessories. Do not
use solvents or other chemicals. Do not wipe with a chemicallytreated cleaning cloth.
• Keep all products, cords, and cables away from operating ma-
chinery. As with all corded products, there is a danger of strangulation if a cord should become wrapped around your neck.
• Do not disassemble or insert anything into the headset or charg-
ing cradle because this may cause damage to the internal components or cause injury to you.
• Comply with laws regarding use of a mobile phone and headset
while driving. If you use the headset while driving, make sure that
your attention and focus remain on driving safely.
• Observe all signs and instructions that require an electrical device
or radio product to be switched off in designated areas, such as
gas/refueling stations, hospitals, blasting areas, potentially explosive atmospheres or aircraft.
• Do not force tip of the headset earpiece down the ear canal. If
the earpiece tip becomes lodged in the ear canal, seek medical
attention immediately.
• Applying excessive pressure to the earpiece may injure the outer
ear. Do not wear the headset while sleeping or in other situations
where pressure may be exerted against the earpiece.
Getting assistance
For assistance with this product, visit www.us.playstation.com/
Support or call SCEA Consumer Services at 1-800-345-7669.
PART NAMES
Power button
Volume - button
Mic muting button
Charging cradle
Ear clip
Power indicator
Mic muting indicator
Volume + button
Bluetooth® headset
USB connector
USB connector
USB cable
mini-B connector
PS3™ system
Charging cradle
CHARGING YOUR HEADSET
Your headset performs best when fully charged. You can charge the headset by using the charging cradle or directly from a USB cable.
Warning
Do not wear your headset while it is connected to the charging cradle or a USB cable.
5
Charging time
3 hours Approximate time for full charge using charging cradle or USB
1 hour Minimum charge before rst use
®
Hint: To check the headset’s battery level, you must use the automatic mode (not Bluetooth
when you pair the headset with your PS3™ system. Then you can see the level on the monitor connected to the PS3™ system as
described in “Battery level.”
discovery mode; see “Pairing your headset”)
Using the charging cradle
For convenience, you can connect the charging cradle to a USB device to allow easy access to the headset.
1
1
Check that the device to be connected to the
charging cradle (the PS3™ system in this
example) is turned on.
4
2 Insert the USB connector of the supplied USB
cable into an available USB connector (port).
3 Insert the mini-B connector of the USB cable
into the USB connector on the charging cradle.
3
2
When power is rst applied to the headset, the mic muting indicator lights up solid red for two seconds and then ashes on and off every
three seconds until the headset is fully charged.
4 Place the headset into the charging cradle.
Loading...