Index ................................................................... 13
EN
Actual total number:Sony CDX-52RF (E, S, C) 3-856-013-32 (1)
3
Getting Started
2
EN
Resetting the hideaway
unit
Before operating the unit for the first time or
after replacing the car battery, you must reset
the hideaway unit.
Press the RESET button with a pointed object,
such as a ballpoint pen.
RESET button
Preparing the CD changer
1
Labelled surface
10 discs, one in each slot
To remove
µ
To open the door, first release the catch by
turning it in the direction shown.
3
Disc magazine
To remove
EJECT
4
Note
Lever
To listen to an 8 cm CD, use the separately sold Sony CD,
adapter CSA-8. Be sure to always use the specified
adapter, as failing to do so may cause a malfunction of the
unit. If you use any other adapter, the unit may not operate
properly. When using the sony CD adapter, make sure that
the three catches on the adapter are firmly latched onto the
8 cm CD.
If the disc magazine does not lock properly
Take out the disc magazine, press (EJECT),
and reinsert it.
4
Actual total number:Sony CDX-52RF (E, S, C) 3-856-013-32 (1)
Use the unit with the door closed
Otherwise, foreign matter may enter the unit,
and contaminate the lenses inside the CD
changer.
Notes on the disc magazine
• Do not leave the disc magazine in locations
with high temperatures and high humidity,
such as on a car dashboard or in the rear
window where the disc magazine will be
subjected to direct sunlight.
• Do not insert more than one disc at a time
into a slot, otherwise the changer and the
discs may be damaged.
• Do not drop the disc magazine or subject it to
a violent shock.
Preparing the wireless
remote
Notes on the lithium battery
• Keep the lithium battery out of the reach of
children.
Should the battery be swallowed,
immediately consult a doctor.
• Wipe the battery with a dry cloth to assure a
good contact.
• Be sure to observe the correct polarity when
installing the battery.
• Do not hold the battery with metallic
tweezers, otherwise a short-circuit may
occur.
Mounting the wireless remote
Use the supplied velcro tapes and mount the
wireless remote to a suitable location where it
will not interfere with your driving.
Velcro tapes
to where it is
going to be
mounted
Installing the battery
+ side up
Replace the battery with a Sony CR2025 or
Duracell DL-2025 lithium battery. Use of
another battery may present a risk of fire or
explosion.
When the battery becomes weak, you will not
be able to operate the unit with the wireless
remote.
Battery life is approx. six months although it
depending on the conditions of use.
WARNING
Battery may explode if mistreated.
Do not recharge, disassemble or dispose of
in fire.
Changing the transmitting
frequency
Because this unit processes CD playback
sound through an FM tuner, there may be
interference noise during CD playback. In this
case change the frequency of the modulated
RF signal transmitted from hideaway unit. The
initial setting is 88.3 MHz.
1 Press (REP) for two seconds.
2 Press either the left or right side of
(AMS) to select the frequency.
Each time you press (AMS), the frequencies
change as follows:
=:
88.3 MHz n 89.9 MHz n 89.7 MHz n
89.5 MHz n 89.3 MHz n 89.1 MHz n
88.9 MHz n 88.7 MHz n 88.5 MHz n
88.3 MHz
+:
88.3 MHz n 88.5 MHz n 88.7 MHz n
88.9 MHz n 89.1 MHz n 89.3 MHz n
89.5 MHz n 89.7 MHz n 89.9 MHz n
88.3 MHz
EN
Getting Started
3 Press (REP) for two seconds.
Note
Be sure to set the frequency of your FM tuner to that of the
newly selected frequency.
Actual total number:Sony CDX-52RF (E, S, C) 3-856-013-32 (1)
5
EN
DISC
CD Changer
Listening to a CD
1 Turn on the FM tuner of the car audio.
2 Adjust the selected transmitting
frequency with the wired remote.
(88.3 MHz/88.5 MHz/88.7 MHz/88.9 MHz/
89.1 MHz/89.3 MHz/89.5 MHz/89.7 MHz/
89.9 MHz)
3 Press ^.
CD playback starts.
When the unit is used in a car without an
accessory position on the ignition key switch
Be sure to press (OFF) on the wireless remote to turn the
system off to avoid battery wear while the engine is not
running.
If the POWER SELECT switch on the hideaway unit is set
to the OFF position and the display on the wired remote is
turned off, you will not be able to start CD playback with
the wireless remote. In this case, press ^ on the wired
remote .
Locating a specific disc
— Disc Select
During playback, press (DISC+) or
(DISC–) once for each disc you wish to
skip.
DISC
To locate succeeding discs
To locate previous discs
Stopping CD play
Press (OFF).
Notes
• When CD playback is stopped, you may hear some noise
from the speakers. To prevent this from happening, turn
the volume down before stopping CD playback.
• If you turn off the ignition switch of your car without
stopping CD playback, it will automatically resume CD
playback from where it was stopped the next time you
turn on the ignition switch.
Listening to the radio or a tape
Be sure to stop CD playback before you start
listening to the radio or a tape.
Note
Be sure to stop CD playback, otherwise there may be some
interference with radio reception.
4 Adjust the volume with the volume
control on the car audio.
All the tracks play from the beginning.
Locating a specific track
— Automatic Music Sensor (AMS)
During playback, press either side of
(AMS) once for each track you wish to
skip.
To locate
previous tracks
AMS
To locate
succeeding tracks
Locating a specific point in a track
— Manual Search
During playback, press and hold
(DISC+)or (DISC–). Release the button
when you have found the desired part.
DISC
DISC
To search forward
To search backward
6
Playing tracks in random
order
You can select:
• SHUF 1 to play the tracks on the current disc
• SHUF 2 to play all the discs in a random
To go back to the normal playback mode, press
(SHUF) until “SHUF” disappears.
— Shuffle Play
in a random order.
order.
Press (SHUFFLE) or (SHUF) repeatedly
until the desired setting appears (SHUF 1
or SHUF 2).
n SHUF 1 n SHUF 2 n Cancel (SHUF off)
Shuffle play starts.
Actual total number:Sony CDX-52RF (E, S, C) 3-856-013-32 (1)
Playing tracks repeatedly
— Repeat Play
You can select:
• REP 1 to repeat the track.
• REP 2 to repeat the disc.
Press (REPEAT) or (REP) repeatedly until
the desired setting appears (REP 1 or REP
2).
n REP 1 n REP 2 n Cancel (REP off)
Repeat play starts.
To go back to the normal playback mode, press
(REP) until “REP” disappears.
Changing the output level
You can select the output level from the CD
changer. Normally the system is used in the
initial output level, change the level if
necessary.
1 Press (REP) for two seconds.
2 Press (REP) momentarily.
Additional
Information
Precautions
• If your car was parked in direct sunlight
resulting in a considerable rise in
temperature inside the car, allow the system
to cool off before operating it.
• If no power is being supplied to the system,
check the connections first. If everything is in
order, check the fuse.
• Avoid installing the CD changer, wireless
remote, and wired remote in places:
— subject to temperatures exceeding 55 °C.
— subject to direct sunlight.
— near heat sources (such as heaters).
— exposed to rain or moisture.
— exposed to excessive dust or dirt.
— subject to excessive vibration.
If you have any questions or problems
concerning your unit that are not covered in
this manual, please consult your nearest Sony
dealer.
EN
CD Changer/Additional Information
00 0
3
CD
LEVEL
Initial setting
3 Press either the left or right side of
(AMS) to select the output level.
To decrease the output level
=:
To increase the output level
+:
0 1CD
LEVEL
00 00
4
CD
LEVEL
4 Press (REP) for two seconds.
7
Actual total number:Sony CDX-52RF (E, S, C) 3-856-013-32 (1)
Notes on compact discs
A dirty or defective disc may cause sound
drop-outs during playback. To enjoy optimum
sound, handle the disc as follows.
Handle the disc by its edge, and do not touch
the unlabelled surface.
This way
Moisture condensation
On a rainy day or in a very damp area,
moisture may condense on the lenses inside
the unit and the unit will not operate properly.
In this case, remove the disc and wait for
about an hour until the moisture has
evaporated.
If you have any questions or problems
concerning your system that are not covered in
this manual, please consult your nearest Sony
dealer.
EN
Do not stick paper or tape on the labeled
surface.
Not this way
Do not expose the discs to direct sunlight or
heat sources such as hot air-ducts, or leave it in
a car parked in direct sunlight where there can
be a considerable rise in the temperature inside
the car.
Not this way
Before playing, clean the discs with an optional
cleaning cloth. Wipe each disc in the direction
of the arrows.
Do not use solvents such as benzine, thinner,
commercially available cleaners, or antistatic
spray intended for analog discs.
This way
Maintenance
Fuse replacement
If the fuse blows, check the power connection
and replace the fuse. If the fuse blows again
after replacement, there may be an internal
malfunction. In this case, consult your nearest
Sony dealer.
Warning
Use the specified amperage fuse.
Use of a higher amperage fuse may cause
serious damage.
8
Actual total number:Sony CDX-52RF (E, S, C) 3-856-013-32 (1)
Location of controls
Wired remote (RM-X57)
5 3CD
TRACK DISC
Refer to the pages for details.
1 ( (play/pause) indication
Lights during CD playback and flashes
when the pause button is pressed.