Page 1
™
Strong Arm
with Plastic Bend Support
Inside Mount Instruction Sheet
1
Determine stub out height.
Secure both brackets to one
side of the stud bay.
2
Working from the back of the
bracket, insert fl exible tube
through the nose of the front
block then bend tube and
capture in place at tail end of
elbow.
3
Slide plastic elbow block
assembly to desired stub out
location. Insert two screws
into each block and tighten.
Tightening screws prevents
lateral movement of blocks on
4
Bend the loose ends of the
5
Secure each bracket
with
brackets and prevents elbow
from swiveling.
6
Installation complete.
Strong Arm brackets as close
as possible to the Plastic Bend
Support in opposite directions.
screws. Start with lower bracket
to keep installation level.
Patent # 8,061,390
Patent # 8,141,831
1-800-821-3944 • www.siouxchief.com
#IS-525-PBL ©2010 SIOUX CHIEF MFG.
Loading...