Sinbo SFH 6926 User Manual

SFH 6924

2000W

SFH 6925

1500W

SFH 6926

1000W

SFH 6924, SFH 6925, SFH 6926 CONVECTION HEATER

INSTRUCTION MANUAL

- 2000BT

- 1500BT

- 1000BT

ENGLISH

SINBO SFH 6924, SFH 6925, SFH 6926 CONVECTION HEATER INSTRUCTION MANUAL

Please read this guidance carefully before using the electrical appliance, so that you can use it correctly. Please keep well with this guidance.

Brief Introduction of the product:

The panel heater adopts the heating element which with inside steel stainless tube punched with aluminum .It with reasonable design, nice outlook, easy and safe to operating. It is popular heater products in European market with advantage of high heating efficiency, quickly warm, heating centralize, no bright lamp, no dry feeling, etc. It with adjustable thermostat and inside thermal cut-out, with 2 power setting, suitable using at home and similar place.

Assemble before you use:

Please assemble the feet and the body in the order given in the picture below:

Place the convector on the flat desk or carton.

2. Insert the 4 position holes of the feet into the position holes of the body.

3. Tight the fixed screw to connect body and feet.

Technical parameters: SFH 6924: 220-240V, 50Hz, 2000W SFH 6925: 220-240V, 50Hz, 1500W SFH 6926: 220-240V, 50Hz, 1000W

- 1 -

A. Product Structure:

Hot air outlet

Plastic Handle

Indicator

Thermostat knob

Front Cover

Truckle

B. Usage:

Before using, please check if the voltage of products are the same of local place. * Insert the plug into 220-240V/50Hz socket. * Press the switch.

“O”position is off. “I” position is lower power setting “II” position is higher power setting.

SFH 6924: SFH 6925: “I” is for 750W, “II” is for 1500W. SFH 6926: “I” is for 1000W.

* You can change the temperature by turning the thermostat knob which from “MIN to MAX. “ MIN “position is lowest temperature, “MAX “position is highest temperature.

Installation:

* When using stand unit, put the feet into the fix holes at the bottom of the unit. And then fix the screws. Then you can use the unit by putting the unit on the flat place. * When using wall mount unit, before drilling the wall make sure the area is free of electrical wires or pipes. To fix your heater to the wall, use the appropriate screws.

“I” is for 1000W, “II” is for 2000W.

Power Switch

Reference as the pictures below:

- 2 -

* If there has ceiling or any articles on top of unit, the distance should be bigger than 600mm. The small distance will cause distortion and fire.

IMPORTANT SAFETY INSTRUCTIONS

This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.

2. Children should be supervised to ensure that they do not play with the appliance.

3. The heater must not be located immediately below a socket-outlet.

4. If the supply cord is damaged, it must be replaced by the manufacturer or its service

agent or a similar qualified person in order to avoid a hazard.

5. Cover the appliance or incorrect placement will cause the fire. Do not cover and using convert direction.

6. Before first usage, please check your voltage and frequency is same as rating label The socket must be more than 10A for fear of any accident.

7. Before connecting the electricity, please remove the ligation wire in order to prevent overheating.

- 3 -

+ 9 hidden pages