Siemens MOBYF-XXX80 Basic requirements

Configuration and Mounting Guidelines

3.1 Basic Requirements

Warning

!

Do not make changes on the devices.
Violation will invalidate interference emission certification (BZT, FCC), CE,
and the manufacturer’s warranty.

Note

This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:

S Reorient or relocate the receiving antenna.
S Increase the separation between the equipment and receiver.
S Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

S Consult the dealer or an experienced radio/TV technician for help.

3-2

To choose the correct MOBY F components, apply the following criteria to
your particular application:

S Transmission distance (i.e., read/write distance)
S The amount of data to be transferred
S Metal-free spaces for MDS and SLG (antenna)
S Static of dynamic transmission of the data
S Speed for dynamic transmission
S Tolerances of the tracking
S Environmental conditions (e.g., moisture, temperature, chemical effects,

and so on)

S Maximum write frequency per MDS

MOBY F Configuration, Installation and Service Manual

(4) J31069-D0113-U001-A0-7618