Shop fox W1750 User Manual

Introduction

Your new Model W1750 Bandsaw Stand (Figure 1) is
designed for use with the Model W1749 9" Bandsaw.

Inventory (Figure 2) Qty

A. Long Top Brackets .........................................2

B. Short Top Brackets ........................................2

C. Long Bottom Brackets ....................................2

D. Short Bottom Brackets ....................................2

E. Stand legs ...................................................4

Model W1750

Bandsaw Stand

Instruction Sheet

Hardware Bag (Not Shown)

• Carriage Bolts

• Hex Bolts

• Hex Nuts

• Flat Washers

5

⁄16"-18 x 1⁄2" ........................... 16

5

⁄16"-18 x 13⁄4" .................................4

5

⁄16"-18 ........................................ 20

5

⁄16" ........................................ 24

Specifications

• Overall Size ............... 211⁄2" W x 273⁄4" L x 271⁄4" H

• Weight .................................................12 lbs

Assembly

We recommend assembling the stand upside down. To
make it easier,
you assemble the stand

have an assistant hold the pieces while

.

NOTICE

Do not final tighten stand bolts until all components
have been assembled.

Figure 1. Model W1750.

A

B

C

Figure 2. Model W1750 Inventory.

Long Top

Bracket

Leg

D

E

To assemble the stand, do these steps:

1. Mount a long top and bottom bracket to a stand leg

and loosely secure with
bolts, flat washers, and hex nuts as shown in

two 5⁄16"-18 x 1⁄2" carriage

Figure 3.

Long

Bottom

Bracket

Figure 3. Top and bottom long brackets

secured to a stand leg.

2. Secure a second leg to the long top and bottom

brackets with two 5⁄16"-18 x 1⁄2" carriage bolts, flat
washers and hex nuts as shown in

Figure 4.

3. Repeat Steps 1–2 to build another leg assembly.

4. Secure the short top and bottom brackets to one of

the leg assemblies as shown in

5

⁄16"-18 x 1⁄2" carriage bolts, flat washers, and hex

nuts.

Figure 5 with four

W1750 Bandsaw Stand

Leg

5. Fasten the stand assembly to the other leg assembly

and secure with the remaining fasteners (

Figure 6).

6. Turn the stand upright and adjust it so the legs are

evenly positioned, then tighten all the stand fasten­ers.

Mounting

To mount the stand to the bandsaw, do these steps:

1. Align the four holes on the bottom of the Model

W1749 with the corresponding holes on the Model
W1750 top.

2. Using two 12mm open-end wrenches, secure the

5

stand to the bandsaw with four
bolts, four hex nuts, and eight
shown in

Figure 7.

⁄16"-18 x 13⁄4" hex

5

⁄16" flat washers as

Customer Service

For questions contact Woodstock International Technical
Support at [phone], or send e-mail to: tech-

[e-mail]

.

Figure 4. A completed leg assembly.

Short Top Brackets

Short Bottom Brackets

Figure 5. Short top and bottom brackets

secured to a leg assembly.

-2-

Figure 6. Completed stand assembly.

Hex
Bolt

Flat
Washers

Hex
Nut

Figure 7. Mounting Model W1749 bandsaw
to W1750 stand (2 mounting holes shown).